Blue Rhino 163010 General Components & Features, Additional Requirements, Attach Legs to Base

Page 7

Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Assembly Instructions

General Components & Features

Familiarize yourself with all components before proceeding. Refer to page 5 for hardware and components, and page 19 for specifications.

Note: All the hardware is in a plastic bag packed in the emitter top inside of a cardboard divider inside the cap. This also includes the cup and cap support.

Do NOT attempt assembly unless all components are available. If you believe a component is missing or damaged, contact 1-800-762-1142 for assistance.

Additional Requirements

The following items are not included, but are necessary for the proper assembly of your heater. Do NOT attempt to assemble without proper tools.

(1) 7/16” Wrench

(1) 7/16” Socket Wrench

(1) #2 Phillips Head Screwdriver

(1) Leak Detection Solution (Instructions to prepare are included in step 13)

Note: You must follow all steps to properly assemble heater.

Step 1 – Attach Legs to Base

Note: Attach Leg with notches for hinges as shown at left.

•Secure each leg to base using (2) Large Bolts, (2) Lock Washers and (2) Large Nuts per leg. Finger tighten only.

• Do not fully tighten until Step 2.

Owner’s manual and assembly instructions: model 163010 natural gas outdoor patio heater

12/4/02

6

Image 7

Contents Manuel d’Utilisation 12/4/02 12/4/02 For Your Safety Safety FirstFor Your Safety Picture Qty Additional Requirements General Components & FeaturesAttach Legs to Base Attach Cylinder Shroud to Legs Attach Cap Assembly to Legs/Insert Gas LineAssemble Cup, Plate & Ring to Cap Assemble Emitter Assemble Emitter TopAttach Engine to Post Connect Gas Line to Engine Connect Engine/Post Assembly to CapAttach Dome to Emitter Check for Leaks Secure Gas LineCheck Gas Line / Cylinder valve for leaks Replace Engine Access Panel Install Cylinder Access PanelBefore Lighting Before Turning Gas Supply onLighting Re-lighting When heater is onShut Down After Operation Before OperatingIf the problem is This condition exists Then do this TIP During periods of extended inactivity or when transporting ServiceBetween uses Warranty Period Heat Range Safety FeaturesCertifications Rating12/4/02 Avertissement Table des matières Section La sécurité avant tout La sécurité avant toutBonbonne de gaz de 9 kg Pour Votre SécuritéQuincaillerie PiècesInstructions de montage Accessoires SupplémentairesÉtape 1 Fixer les jambes au socle Conseil Étape 7 Fixer le moteur au pôle Étape 6 Assembler l’émetteurÉtape 10 Fixer le dôme à l’émetteur Étape 9 Raccorder la conduite de gaz au moteurÉtape 15 Rechercher une fuite potentielle Étape 11 Fixer la conduite de gazVérifier la conduite de gaz et la bonbonne Étape 15 Replacer le panneau d’accès du moteur Étape 14 Installer le panneau d’accès de la bonbonneAllumer l’appareil Avant d’ouvrir la commande de gaz onFonctionnement Avant d’allumer l’appareilRallumer l’appareil Lorsque l’appareil est allumé onÉteindre l’appareil Après toute utilisation Vérifications à effectuer avant toute utilisationDans le cas suivant Problème Pour corriger le problème Guide de dépannageEntretien Rangement Service après-venteEntre chaque utilisation Période de garantie GarantieCaractéristiques techniques Page NASDAQ-RINO