Blue Rhino 163010 owner manual Before Turning Gas Supply on, Before Lighting

Page 13

Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Operation

Caution: Do NOT attempt to operate heater until you have read and understand all precautions in section 1 “Safety First.”

Before Turning Gas Supply ON

Your heater was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or any other enclosed area.

Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or liquids.

Ensure that there is no obstruction to air ventilation.

Be sure all gas connections are tight and there are no leaks.

Be sure the cylinder cover is clear of debris.

Be sure any component removed during assembly or servicing are replaced and fastened prior to starting.

Before Lighting

WARNING

FOR YOUR SAFETY:

If at any time you are unable to light pilot and smell gas, wait 5 minutes to allow gas to dissipate before attempting to light heater.

WARNING

FOR YOUR SAFETY:

Do NOT touch or move heater for at least 45 minutes after use.

Allow all burner elements to cool before touching.

• Heater should be thoroughly inspected before each use, and by a

View Hole

qualified service person at least annually.

 

• If relighting a hot heater, always wait at least 5 minutes.

 

• Inspect the hose assembly for evidence of excessive abrasion, cuts,

 

or wear. Suspected areas should be leak tested. If the hose leaks, it

 

must be replaced prior to operation. Only use the replacement hose

 

assembly specified by manufacturer.

 

Lighting

Note: This heater is equipped with a Pilot Light that allows for safer startups and shutdowns. Pilot must be lit before Main Burner can be started.

Turn Cylinder Valve OFF.

Push Control Knob IN and turn to OFF.

Wait 5 minutes for any gas to clear.

Turn Cylinder Valve ON.

Open Viewing Hole by sliding cover to either side.

Push Control Knob IN and rotate to Pilot position.

Note - For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge air from gas lines before proceeding.

Push Igniter button once. Pilot Light flame will appear and be visible through Viewing Hole.

Release Control Knob after 30 seconds. Pilot Light will remain lit. If not, return to step 1.

Pilot

LOW

(Push in)

 

HIGHOFF

Pilot

LOW

(Push in)

 

HIGHOFF

Owner’s manual and assembly instructions: model 163010 natural gas outdoor patio heater

12/4/02

12

Image 13
Contents Manuel d’Utilisation 12/4/02 12/4/02 For Your Safety Safety FirstFor Your Safety Picture Qty Additional Requirements General Components & FeaturesAttach Legs to Base Attach Cylinder Shroud to Legs Attach Cap Assembly to Legs/Insert Gas LineAssemble Cup, Plate & Ring to Cap Assemble Emitter Assemble Emitter TopAttach Engine to Post Connect Gas Line to Engine Connect Engine/Post Assembly to CapAttach Dome to Emitter Check for Leaks Secure Gas LineCheck Gas Line / Cylinder valve for leaks Replace Engine Access Panel Install Cylinder Access PanelBefore Lighting Before Turning Gas Supply onLighting Re-lighting When heater is onShut Down After Operation Before OperatingIf the problem is This condition exists Then do this TIP During periods of extended inactivity or when transporting ServiceBetween uses Warranty Period Certifications Safety FeaturesRating Heat Range12/4/02 Avertissement Table des matières Section La sécurité avant tout La sécurité avant toutBonbonne de gaz de 9 kg Pour Votre SécuritéQuincaillerie PiècesInstructions de montage Accessoires SupplémentairesÉtape 1 Fixer les jambes au socle Conseil Étape 7 Fixer le moteur au pôle Étape 6 Assembler l’émetteurÉtape 10 Fixer le dôme à l’émetteur Étape 9 Raccorder la conduite de gaz au moteurÉtape 15 Rechercher une fuite potentielle Étape 11 Fixer la conduite de gazVérifier la conduite de gaz et la bonbonne Étape 15 Replacer le panneau d’accès du moteur Étape 14 Installer le panneau d’accès de la bonbonneFonctionnement Avant d’ouvrir la commande de gaz onAvant d’allumer l’appareil Allumer l’appareilRallumer l’appareil Lorsque l’appareil est allumé onÉteindre l’appareil Après toute utilisation Vérifications à effectuer avant toute utilisationDans le cas suivant Problème Pour corriger le problème Guide de dépannageEntretien Rangement Service après-venteEntre chaque utilisation Période de garantie GarantieCaractéristiques techniques Page NASDAQ-RINO