Aruba Spa 2003 Serenade, 2003 Escape Care For Your Spa, Draining Your Spa, Causes of pH change

Page 26

Causes of pH change:

Causes of pH change:

•adding water.

•rain.

•bather load.

•adding chemicals.

•dust.

•algae.

CARE FOR YOUR SPA

DRAINING YOUR SPA

Drain and re-fill the spa as indicated below:

Average Use:	Every 60 - 90 days
Heavy Use:	Every 30 days
After Parties:	Drain

Before draining your spa you may add whirl-o-clean to the warm water and start the pump for about 30 minutes. This will help in eliminating grease and oils in the plumbing and jets.

WARNING

Do not leave your spa exposed to direct sunlight when there is no water in the spa. Exposure to direct sunlight could damage the spa shell and void your warranty.

To drain the spa:

1.Turn off all power to your spa.

2.Attach a hose to the hose bib at the bottom of the spa and gravity drain by the siphon method.

3.Clean the surface (see “Spa Surface” later in this section).

4.Refill the spa. Follow the initial start-up procedures to re- prime the spa.

24

Image 26

Contents ARUBA SPAS Box 2266 Station R Kelowna, BC V1X 4K6 TABLE OF CONTENTS HAZARD INTRODUCTIONDear Aruba Customer HOW YOUR ARUBA SPA IS BUILT GETTING STARTED TOOLS REQUIRED FOR INSTALLATION ITEMS REQUIRED FOR THE INSTALLATION OF YOUR SPAthese safety IMPORTANT SAFETY INSTRUCTIONSHAZARD using yourPOSITIONING YOUR SPA YARD INSTALLATIONDECK INSTALLATION INDOOR INSTALLATION ELECTRICAL CONNECTION ELECTRICAL CONNECTION ACCESSIMPORTANT SAFETY INSTRUCTIONS GND N L1 L2START-UPPREPARATIONS Do not run the pump until the spa is full ofKnife Valve #2 INITIAL START-UPKnife Valve #1 Pump40 CELSIUS 104 F This system should be set to maintaina water temperature NO GREATER THAN Heat s and Heat t buttons SPA OPERATIONS GUIDETopside Control Component Identification Invert ButtonFilter Cycle Programming Pump buttonLight CELSIUS OR FAHRENHEITAll jet trim kits must be properly seated or HYDROTHERAPY JETSMicro Directional air flow may be restrictedSwirl Jet Cluster JetsMassage Jet chemical treatment with an ozonator OZONATORS-OPTIONALIt is necessary to use Chlorine or Bromine This system only accepts a 220v OzonatorTROUBLE SHOOTING Display flashes FLO FLOW CHEMICAL MAINTENANCE INITIAL START UP PROCEDURES Weekly WATER MAINTENANCE SCHEDULECONDUCTING PROPER WATER TESTS Sanitizers such as SodiumBROMINE Low pH CHEMICAL TABLE OF EQUIVALENTS CHARTPROBLEMS ASSOCIATED WITH IMPROPER WATER BALANCE High pHCauses of pH change CARE FOR YOUR SPADRAINING YOUR SPA To drain the spaMake sure you replace your filter cartridges FILTER CLEANINGSPA SURFACE at least once every six monthsWhen cleaning the surface use only acrylic CABINETCOVER cleanersFading and discolouration SPECIAL COLD WEATHER INSTRUCTIONS Smart Protect Warranty service agent at WARRANTY INFORMATIONand its exclusions For warranty service contact a 1-877--877-2087WARRANTY FIVE YEAR LIMITED NO LEAKONE YEAR LIMITED SKIRT L I M I T E DREGISTRATION To validate this warranty, the original purchaser must complete the warranty registration card and mail it to ARUBA SPAS within 30 days of deliv- ery of the spa P Spa won’t turn on TROUBLE SHOOTING GUIDEPROBLEM DIAGNOSIS ACTION P Spa comes on by itselfP GFCI shuts down frequently P Water not cleanP Motor shuts down while in use P Abnormal water usageP Foaming of water P pH is too lowP Formation of chloramines P Scale depositsCIRCULATION PUMP OPERATIONS Optional PurchaseMaintenance WEEKLY MAINTENANCE SCHEDULEClean DATE920 Leathead Road Kelowna, BC V1X 2J8