Alamo 5, 6 manual To the OWNER/OPERATOR/DEALER

Page 111

TO THE OWNER/OPERATOR/DEALER

To keep your implement running efficiently and safely, read your manual thoroughly and follow these directions and the Safety Messages in this Manual. The Table of Contents clearly identifies each section where you can easily find the information you need.

The OCCUPATIONAL SAFETY AND HEALTH ACT (1928.51 Subpart C) makes these minimum safety require- ments of tractor operators:

REQUIRED OF THE OWNER:

1.Provide a Roll-Over-Protective Structure that meets the requirements of this Standard; and

2.Provide Seat belts that meet the requirements of this paragraph of this Standard and SAE J4C; and

3.Ensure that each employee uses such Seat belt while the tractor is moving; and

4.Ensure that each employee tightens the Seat belt sufficiently to confine the employee to the protected area provided by the ROPS.

REQUIRED OF THE OPERATOR

1.Securely fasten seat belt if the tractor has a ROPS.

2.Where possible, avoid operating the tractor near ditches, embankments, and holes.

3.Reduce speed when turning, crossing slopes, and on rough, slick, or muddy surfaces.

4.Stay off slopes too steep for safe operation.

5.Watch where you are going - especially at row ends, on roads, and around trees.

6.Do not permit others to ride.

7.Operate the tractor smoothly - no jerky turns, starts, or stops.

8.Hitch only to the drawbar and hitch points recommended by the tractor manufacturer.

9.When the tractor is stopped, set brakes securely and use park lock, if available.

Keep children away from danger all day, every day...

Equip tractors with rollover protection (ROPS) and keep all machinery

guards in place...

Please work, drive, play and live each day with care and concern for your safety and that of your family and fellow citizens.

Image 111
Contents Switchblade 5/6 To the Owner/Operator/Dealer Page Alamo Industrial Division is willing to provide Table of Contents Ledger Plates Safety Section Safety SB5/6 03/09 Safety Section Safety Safety Safety Safety S3PT-4 SBM-7 Safety See Your Alamo Dealer Safety QTY Type Description Peligro Decal Description Safety Instructions Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Operation Section Operation Operator Requirements OperationTractor Requirements and Capabilities Tractor Safety DevicesTractor Horsepower Tractor RequirementsTractor Hydraulics Front End WeightPower Take Off PTO Getting on and OFF the TractorDismounting the Tractor Boarding the TractorStarting the Tractor PRE-OPERATION Inspection and Service Sickle Bar Pre-Operation Inspection/Service Tractor Pre-Operation Inspection/ServiceFrame Assembly OPS-SB Hydraulic PUMP/OIL Reservoir Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock SettingDriving the Tractor and Switch Blade Operating the Tractor and Implement Motor Control Cutter BAR BREAK-BACK Operating the Switch Blade Shutting Down the Switch Blade Transporting the Tractor and Implement Tractor and Switch Blade StorageTransporting on Public Roadways Operation Operation Hauling the Tractor and Implement Page Maintenance Section Lubrication Information MaintenanceReservoir OIL & Filter Maintenance Initial Hydraulic System CleaningCutterbar Adjustments Guard AdjustmentCutterbar Alignment Clips Wear PlateSB5/6 03/09 Maintenance Section Pump & Motor Hydraulic SystemLedger Plates Cylinder Rod MaintenancePage ALAMO-INDUSTRIAL To the OWNER/OPERATOR/DEALER Switchblade 5/6 SOM 03/09