Alamo 5, 6 manual Federal Laws and Regulations

Page 25

SAFETY

Federal Laws and Regulations

This section is intended to explain in broad terms the concept and effect of federal laws and regulations concerning employer and employee equipment operators. This section is not intended as a legal interpretation of the law and should not be considered as such.

Employer-Employee Operator Regulations

U.S. Public Law 91-596 (The Williams-Steiger Occupational and Health Act of 1970) OSHA

This Act Seeks:

“...to assure so far as possible every working man and woman in the nation safe and healthful working conditions and to preserve our human resources...”

DUTIES

Sec. 5 (a) Each employer-

(1)shall furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm to his employees;

(2)shall comply with occupational safety and health standards promulgated under this Act.

(b)Each employee shall comply with occupational safety and health standards and all rules, regulations and orders issued pursuant to this Act which are applicable to his own actions and conduct.

OSHA Regulations

OSHA regulations state in part: “At the time of initial assignment and at least annually thereafter, the employer shall instruct every employee in the safe operation and servicing of all equipment with which the employee is, or will be involved.”

Employer Responsibilities:

To ensure employee safety during Tractor and Implement operation, it is the employer’s responsibility to:

1.Train the employee in the proper and safe operation of the Tractor and Implement.

2.Require that the employee read and fully understand the Tractor and Implement Operator’s manual.

3.Permit only qualified and properly trained employees to operate the Tractor and Implement.

4.Maintain the Tractor and Implement in a safe operational condition and maintain all shields and guards on the equipment.

5.Ensure the Tractor is equipped with a functional ROPS and seat belt and require that the employee operator securely fasten the safety belt and operate with the ROPS in the raised position at all times.

6.Forbid the employee operator to carry additional riders on the Tractor or Implement.

7.Provide the required tools to maintain the Tractor and Implement in a good safe working condition and provide the necessary support devices to secure the equipment safely while performing repairs and service.

8.Require that the employee operator stop operation if bystanders or passersby come within 25 feet.

Child Labor Under 16 Years of Age

Some regulations specify that no one under the age of 16 may operate power machinery. It is your responsibility to know what these regulations are in your own area or situation. (Refer to U.S. Dept. of Labor, Employment Standard Administration, Wage & Home Division, Child Labor Bulletin #102.)

SAFETY

SB5/6 03/09

Safety Section 1-19

© 2009 Alamo Group Inc.

Image 25
Contents Switchblade 5/6 To the Owner/Operator/Dealer Page Alamo Industrial Division is willing to provide Table of Contents Ledger Plates Safety Section Safety SB5/6 03/09 Safety Section Safety Safety Safety Safety S3PT-4 SBM-7 Safety See Your Alamo Dealer Safety QTY Type Description Peligro Decal Description Safety Instructions Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Operation Section Operation Operator Requirements OperationTractor Horsepower Tractor Safety DevicesTractor Requirements Tractor Requirements and CapabilitiesPower Take Off PTO Front End WeightGetting on and OFF the Tractor Tractor HydraulicsDismounting the Tractor Boarding the TractorStarting the Tractor PRE-OPERATION Inspection and Service Sickle Bar Pre-Operation Inspection/Service Tractor Pre-Operation Inspection/ServiceFrame Assembly OPS-SB Hydraulic PUMP/OIL Reservoir Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock SettingDriving the Tractor and Switch Blade Operating the Tractor and Implement Motor Control Cutter BAR BREAK-BACK Operating the Switch Blade Shutting Down the Switch Blade Transporting the Tractor and Implement Tractor and Switch Blade StorageTransporting on Public Roadways Operation Operation Hauling the Tractor and Implement Page Maintenance Section Lubrication Information MaintenanceReservoir OIL & Filter Maintenance Initial Hydraulic System CleaningGuard Adjustment Cutterbar AdjustmentsCutterbar Alignment Clips Wear PlateSB5/6 03/09 Maintenance Section Pump & Motor Hydraulic SystemLedger Plates Cylinder Rod MaintenancePage ALAMO-INDUSTRIAL To the OWNER/OPERATOR/DEALER Switchblade 5/6 SOM 03/09