Alamo 02979718C manual Control Cable Connection to Control Stick Assemblies

Page 79

ASSEMBLY

14.Adjust carriage bolt item 1 to obtain a com- pression at impact point of 1/8”-3/16” before STOP “S” hits the arm. Adjust return spring tension (Item 2) to obtain desired mower head return speed.

15.The Mower is now ready to operate. Read the operating instructions and safety instructions before putting the mower to work.

There are obvious and hidden

potential hazards in the operation of this mower. REMEMBER! This machine is often operated in rough terrain conditions and in heavy weeds. Serious injury or even death may occur unless care is taken to ensure the safety of the operator, bystanders, or passersby in the area.

CONTROL CABLE CONNECTION TO CONTROL STICK ASSEMBLIES

First remove the cross-screw from the bottom of the Control Stick Assembly. DO NOT remove the screws that fasten the two housing halves together.

Next, while holding the housing, fully shift the handle in the control stick assembly to expose the female- threaded end of the plunger rod.

UGR 04/06

Assembly Section 3-5

© 2006 Alamo Group Inc.

ASSEMBLY

Image 79
Contents Under the Guardrail To the Owner/Operator/Dealer Page Alamo Industrial Division is willing to provide Table of Contents Page Safety Section Safety Safety Safety UGR 04/06 Safety Section Safety Safety Blade SBM-7 Safety STI-3 Decal Location QTY Type Description Reflect Safety Safety Safety Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Mounting on Bare Tractor Receiving InstructionsSee Figure Asm-R-0242 Assembly Control Cable Connection to Control Stick Assemblies Assembly Operation Section Operation Operator Requirements OperationTractor Requirements and Capabilities Tractor Safety DevicesTractor Horsepower Tractor RequirementsTractor Hydraulics Getting on and OFF the TractorBoarding the Tractor Dismounting the Tractor Starting the Tractor PRE-OPERATION Inspection and ServiceOperation Tractor Pre-Operation Inspection/Service Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Do not Operate an Unsafe Tractor or Mower Rotary Mower PRE-OPERATION Inspection Operating the Tractor and Implement Motor Control Position ControlsMower Break Back Tractor Mowing Speed Transporting on Public Roadways Transporting the Tractor and ImplementOperation Hauling the Tractor and Implement Operation Page Maintenance Section Lubrication Information MaintenanceReservoir OIL & Filter Maintenance Initial Hydraulic System CleaningMaintenance Pump & Motor Hydraulic SystemALAMO-INDUSTRIAL To the OWNER/OPERATOR/DEALER UGR- SOM-04/06 02979718C Printed U.S.A