Alamo 02979718C manual Dismounting the Tractor

Page 86
(SG-9)
(SG-12)
(SG-10)

OPERATION

OPERATION

Never allow children or other persons to ride on the Tractor or Implement.

Falling off can result in serious injury or death.

Do not mount the Tractor while the tractor is moving. Mount the Tractor only when the Tractor and all moving parts are completely stopped.

3.2 Dismounting the Tractor

Before dismounting, park the tractor and implement on a reasonably level surface, apply the parking brake, idle the engine down, disengage the PTO, and lower the implement to the ground. Shut down the tractor engine according to the operator’s manual, remove the key, and wait for all motion to completely stop. Never leave the seat until the tractor, its engine and all moving parts have come to a complete stop.

Use hand rails and steps when exiting the tractor. Be careful of your step and use extra caution when mud, ice, snow or other matter has accumulated on the steps or hand rails. Use all handrails and steps for support and never rush or jump off the tractor. OPS-U- 0009

BEFORE leaving the tractor seat, always engage the brake and/or set the tractor transmission in parking gear, disengage the PTO, stop the engine, remove the key, and wait for all moving parts to stop. Place the

tractor shift lever into a low range or parking gear to prevent the tractor from rolling. Never dismount a Tractor that is moving or while the engine is running. Operate the Tractor controls from the tractor seat only.

UGR 04/06

Operation Section 4-6

© 2006 Alamo Group Inc.

Image 86
Contents Under the Guardrail To the Owner/Operator/Dealer Page Alamo Industrial Division is willing to provide Table of Contents Page Safety Section Safety Safety Safety UGR 04/06 Safety Section Safety Safety Blade SBM-7 Safety STI-3 Decal Location QTY Type Description Reflect Safety Safety Safety Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Receiving Instructions Mounting on Bare TractorSee Figure Asm-R-0242 Assembly Control Cable Connection to Control Stick Assemblies Assembly Operation Section Operation Operation Operator RequirementsTractor Requirements Tractor Safety DevicesTractor Horsepower Tractor Requirements and CapabilitiesBoarding the Tractor Getting on and OFF the TractorTractor Hydraulics Dismounting the Tractor PRE-OPERATION Inspection and Service Starting the TractorOperation Tractor Pre-Operation Inspection/Service Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Do not Operate an Unsafe Tractor or Mower Rotary Mower PRE-OPERATION Inspection Operating the Tractor and Implement Mower Break Back Position ControlsMotor Control Tractor Mowing Speed Transporting the Tractor and Implement Transporting on Public RoadwaysOperation Hauling the Tractor and Implement Operation Page Maintenance Section Maintenance Lubrication InformationInitial Hydraulic System Cleaning Reservoir OIL & Filter MaintenanceMaintenance Hydraulic System Pump & MotorALAMO-INDUSTRIAL To the OWNER/OPERATOR/DEALER UGR- SOM-04/06 02979718C Printed U.S.A