Alamo 02979718C manual Safety

Page 9
(SG-10)
(SG-9)
(SG-8)
(SG-7)
(SG-6)
(SG-5)

SAFETY

Never operate the Tractor or Implement until you have read and completely understand this Manual, the Tractor Operator’s Manual, and each of the Safety Messages found in the Manual or on the Tractor and Implement. Learn

how to stop the tractor engine suddenly in an emergency. Never allow inexperienced or untrained personnel to operate the Tractor and Implement without supervision. Make sure the operator has fully read and understood the manuals prior to operation. (SG-4)

Always maintain the safety decals in good readable condition. If the decals are missing, damaged, or unreadable, obtain and install replacement decals immediately.

Make certain that the “Slow Moving Vehicle” (SMV) sign is installed in such a way as to be clearly visible and legible. When transporting the

Equipment use the Tractor flashing warning lights and follow all local traffic regulations.

Operate this Equipment only with a Tractor equipped with an approved roll- over-protective system (ROPS). Always wear seat belts. Serious injury or even death could result from falling off the tractor--particularly during a turnover when the operator could be pinned under the ROPS.

SAFETY

Do not modify or alter this Implement. Do not permit anyone to modify or alter this Implement, any of its components or any Implement function.

BEFORE leaving the tractor seat, always engage the brake and/or set the tractor transmission in parking gear, disengage the PTO, stop the engine, remove the key, and wait for all moving parts to stop. Place the tractor shift lever

into a low range or parking gear to prevent the tractor from rolling. Never dismount a Tractor that is moving or while the engine is running. Operate the Tractor controls from the tractor seat only.

Never allow children or other persons to ride on the Tractor or Implement.

Falling off can result in serious injury or death.

UGR 04/06

Safety Section 1-3

© 2006 Alamo Group Inc.

Image 9
Contents Under the Guardrail To the Owner/Operator/Dealer Page Alamo Industrial Division is willing to provide Table of Contents Page Safety Section Safety Safety Safety UGR 04/06 Safety Section Safety Safety Blade SBM-7 Safety STI-3 Decal Location QTY Type Description Reflect Safety Safety Safety Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Mounting on Bare Tractor Receiving InstructionsSee Figure Asm-R-0242 Assembly Control Cable Connection to Control Stick Assemblies Assembly Operation Section Operation Operator Requirements OperationTractor Horsepower Tractor Safety DevicesTractor Requirements Tractor Requirements and CapabilitiesGetting on and OFF the Tractor Tractor HydraulicsBoarding the Tractor Dismounting the Tractor Starting the Tractor PRE-OPERATION Inspection and ServiceOperation Tractor Pre-Operation Inspection/Service Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Do not Operate an Unsafe Tractor or Mower Rotary Mower PRE-OPERATION Inspection Operating the Tractor and Implement Position Controls Motor ControlMower Break Back Tractor Mowing Speed Transporting on Public Roadways Transporting the Tractor and ImplementOperation Hauling the Tractor and Implement Operation Page Maintenance Section Lubrication Information MaintenanceReservoir OIL & Filter Maintenance Initial Hydraulic System CleaningMaintenance Pump & Motor Hydraulic SystemALAMO-INDUSTRIAL To the OWNER/OPERATOR/DEALER UGR- SOM-04/06 02979718C Printed U.S.A