Alamo 02979718C manual Assembly

ASSEMBLY

ASSEMBLY

Then, while holding the handle to expose the plunger rod, thread the threaded bead of the cable into the end of the plunger rod and tighten securely. Release the handle, allowing the cable to pull into the control stick assembly.

Once cable is attached to plunger rod, slide the silver conduit sleeve into the bottom of the control stick assembly and align the groove in the conduit sleeve with the cross screw hole.

Finally, reinstall the cross screw and tighten securely.

UGR 04/06 Assembly Section 3-6

© 2006 Alamo Group Inc.