Alamo 95C manual Backfilling, Seat Adjustment, Mounting and Dismounting Buckets

Page 39

OPERATION

To finish the rear wall, lift up and crowd in. Keep the edges of the bucket horizontal.

BACKFILLING

Backfill by lifting the bucket over the spoil pile and then crowding in. Pull both the crowd and lift levers for smooth, even backfilling.

IMPORTANT: Do not backfill by using the swing circuit and dragging the bucket sideways. Doing so can cause damage to the dipstick, boom, swing cylinders, or mainframe.

SEAT ADJUSTMENT

To adjust seat up or down, remove clevis pin (1) and hair pin (2) which secures seat bracket (3) to seat post (4) and raise or lower the seat. Adjust seat forward or rearward by repositioning seat on mounting plate (5).

MOUNTING AND DISMOUNTING BUCKETS

Mount buckets using 1 x 6-5/8 antirotation pins (1), 3/8 x 1- 1/8 cap screws (2) and lock nuts (3).

OPERATION

F-4145 01/11

Operation Section 4-7

© 2011 Alamo Group Inc.

Image 39

Contents

95C To the OWNER/OPERATOR/DEALER Table of Contents Page Safety Section Safety Safety Safety Safety Equipment Operation Safety Instructions and Practices SBH-14 Safety Safety SBH-44 Transporting Safety Instructions and Practices Death. SBH-27 Storage Safety Instructions and Practices See Your Rhino Dealer Parts InformationDecal Location QTY Level Description Decal Description Safety Federal Laws and Regulations Page Introduction Section Introduction General Data Bucket DataCylinder Data Introduction Assembly Section Assembly Installing Three Point Adapter Option Mounting Backhoe to Tractor Operation Section Controls PRE-OPERATION ChecklistOperating Directions Engine Speed Left Hand Stabilizer Right Hand Stabilizer Operating Backhoe Filling Bucket Dumping BucketTrenching Between a Building & Open Excavators Side Slope Excavating or Trenching Finishing Straight Walls MiscellaneousSeat Adjustment BackfillingMounting and Dismounting Buckets Stabilizer Lock Placing the StabilizersSwing Lock Boom LockRemoval from Tractor Storage Page Maintenance Section Cylinder Service Cylinder DisassemblyCylinder Assembly Beginning of Season Hydraulic HosesHydraulic System Reservoir Lubrication Lubrication ChartBucket Tooth Points Tightening Nuts and BoltsHydraulic Troubleshooting Maintenance Torque Settings Valve ServiceMain Relief Replacement Spool Seal InstallationMaintenance Description QTY Parts ListProper Torque for Fasteners Page Rhino Required of the Owner 95C-SOM-01/11 F-4145C Printed U.S.A