Cal Spas GFCI manual Read This First

Page 4

Read This First!

jets, which will relax even the tightest muscles. In addition to the water pressure, you can add air into the spa water with air venturi handles located seat-side that increase the intensity of your massage.

The filtering of this spa is very important. It will minimize cleaning time and the amount of chemicals needed to keep your spa water balanced. The two daily pre- programmed filter cycles of two hours in duration can be increased to six hour cycles if the need arises. This can be accomplished through the topside control panel.

IMPORTANT: Keep the spa covered when not in use!

•Covered spas use less electricity while maintaining a set temperature.

•Covering your spa will protect your spa’s finish from the sun’s ultraviolet rays.

•You are required to keep the spa covered to maintain warranty coverage.

•Covering your spa helps prevent children from drowning in the spa.

Your new spa comes equipped with an electric heater. Following the directions listed below will ensure the most efficient operation:

NOTE: This method is only for spa usage under two hours a week.

•Keep the spa’s operating temperature 5˚F below the desired usage temperature when not in use. One or two hours before use, set the temperature to the desired temperature.

•If the spa usage exceeds two hours a week, the set temperature should remain at the desired usage temperature.

•The air venturis should be used sparingly. When open, water temperature drops quite rapidly and can also dissipate chemicals.

Allowing the water temperature to lower more than 10˚F below the desired usage temperature and reheating it prior to usage will cause the heater to operate longer than it normally would maintaining the desired temperature. Doing this will increase your operating cost and makes your heater work more than necessary.

The filter needs to be cleaned or changed on a regular basis. This process takes only a few minutes and the result is increased water clarity and equipment longevity.

Water level is very important to the operation of your spa. If the water level is too low or too high, your spa will not operate properly. The water level should be to the middle of the skimmer area when the spa is not being used.

We recommend that your spa water be changed every 4 to 6 months. You may find the need to change your spa water more frequently with heavy use. When empty, your spa should be cleaned with a non-abrasive cleaner, such as Cal Spas™ All Surface Cleaner, and then rinsed thoroughly.

See the section “Cleaning and Maintaining Your Spa” for instructions on draining your spa.

When filling your spa, always fill through the skimmer filter canister. Use only regular tap water.

WARNING: DO NOT USE SOFT WATER.

Page 2

2008 Portable Spa Owner’s Manual

LTR20081000, Rev. D

Page 3 Page 5
Image 4
Page 3 Page 5
Contents LTR20081000, Rev. D 12/08 Cleaning and Maintenance Using the Entertainment SystemWater Quality Maintenance Appendix Read This FirstImportant Safety Instructions Read This FirstBasic Spa Information Hyperthermia DangerRead This First Planning the Best Location Preparing for Your New Portable SpaPreparing a Good Foundation Gfci and Wiring Requirements Volt Electrical InstallationTesting the Gfci Breaker Spa Model Gfci Required Wires Required See Configuration InstructionsConfiguring the 6300 Control System Electrical Installation for 11 kW HeaterGfci Wiring Diagram Gas Heater Hook up Preparing for Your New Portable Spa Filling and Powering Up Your Portable Spa Never fill your spa with soft waterOperating Your Spa 5100, 6200 and 6300 Electronic Control OperationSetting Filtration Cycles Diagnostic Messages MeaningLight OptionOperating Your Spa Electronic Control Operation Initial Start-upTime Standard, Economy, Sleep, and StandbyPreset Filter Cycles Setting the Temperature LockClean up Cycle InvertPeriodic Reminder Messages Diagnostic Messages Meaning Action RequiredMessage Frequency Action Required Message Meaning Action Required DryOr --C StbyAuxiliary Panel Configuration Functions Wireless Spa MonitorAuxiliary Control Operation Adjustable Jets Diverter Knobs Air VenturisAdjustable Therapy System Multi-Colored Spa Light OperationAromatherapy WaterfallsWater Quality Maintenance Cal Spas Clear Water PlanAlternative Sanitation Options Before You BeginChemical Safety Bather LoadChemical Overview Physical Chemical HazardsChemical Descriptions For use with any Clear Water PlanFor use with the bromine Clear Water Plan For use with the chlorine Clear Water PlanFor use with the Cal Clarity Bromine Generator Traditional Chemical Start Up Bromine Clear Water Plan Start UpDay One Monday Day Two WednesdayChlorine Clear Water Plan Ozonator Clear Water PlanDay One Monday Day Two WednesdayBromine Generator Clear Water Plan Day Two FridayMaintenance Schedule Removing and Reseating the Pillows Cleaning and MaintenanceSpa Cover Draining Your Portable Spa Freeze damage is not covered by your warrantyWinterizing Cold Climate Draining Cleaning the Cover, Shell and Pillows Cleaning and Replacing the Filter Exclusive Bio-Clean Filter CartridgeUsing the Entertainment System Listening to the RadioInserting and Ejecting a CD or Functions for Aeware DVD playerPlaying a CD Raising and LoweringPlaying a Movie This applies to the Aeware system onlyUsing the Universal Remote Control Using the iPod Docking Station Programming the Universal Remote ControlDevice Manufacturer Device Type Code Replacement Parts AppendixMNW SXW Neck JET, Quad Blaster Power Storm JET, Swirley Valves PillowsDrains WaterfallsReplacement Cabinet Panels FiltersPumps LED LightsAvalon Series CoversClassic / Legacy Series DIJ-404 93 x Fitness Series Family SeriesAppendix Keeping Fit with your Spa Ultimate Fitness Series Exercise ProgramConnecting the Exercise Equipment Cal Spas Chemicals Warranty Warranty Limitations Warranty SpecificsWarranty Exclusions Locating the product serial number

GFCI specifications

Cal Spas GFCI (Ground Fault Circuit Interrupter) is an essential safety feature incorporated in Cal Spas hot tubs and spas, designed to protect users from electrical shocks and enhance overall safety during relaxation. This advanced technology monitors the electrical current flowing through the spa's components, providing peace of mind for families and individuals enjoying their hydrotherapy experience.

One of the main features of the Cal Spas GFCI is its quick response time. The GFCI continuously measures the current balance between the hot and neutral wires. If it detects an imbalance, potentially caused by faulty wiring or a short circuit, it immediately trips the circuit, cutting off power to the unit within a fraction of a second. This rapid response significantly minimizes the risk of electrical accidents, making it a vital component for any outdoor or indoor spa setup.

Another key characteristic of the Cal Spas GFCI is its user-friendly design. The GFCI outlet is often equipped with a reset button, which allows users to quickly restore power once the issue has been addressed. This feature eliminates the need for complicated maintenance procedures, ensuring that users can enjoy their spa without frequent interruptions.

Incorporating state-of-the-art technology, Cal Spas GFCI is designed to withstand the rigors of outdoor environments. The durable exterior of the GFCI unit protects it from exposure to moisture, debris, and other potential hazards, leading to increased longevity and reliability. Moreover, the GFCI meets the highest safety standards and regulations, providing confidence to consumers that they are investing in a safe product.

Another highlight of the Cal Spas GFCI is its compatibility with a variety of hot tub configurations. This flexibility allows it to work seamlessly with different Cal Spas models, delivering consistent safety features across the entire range. Additionally, installation is straightforward, with many users opting for professional installation to ensure it is set up correctly.

In summary, Cal Spas GFCI enhances the safety of hot tub and spa experiences through its quick trip response, durable design, user-friendly functionalities, and compatibility with various models. By integrating this technology, Cal Spas demonstrates its commitment to providing a safe and enjoyable environment for relaxation and rejuvenation.
Top Page Image Contents