Exmark 4500-497 manual Slope Operation, Using the Rollover Protection System Rops

Page 8

Safety

Stop the blades, slow down, and use caution when crossing surfaces other than grass and when transporting the mower to and from the area to be mowed.

Be aware of the mower discharge path and direct discharge away from others.

Do Not operate the mower under the influence of alcohol or drugs.

Use extreme care when loading or unloading the machine into a trailer or truck.

Use care when approaching blind corners, shrubs, trees, or other objects that may obscure vision.

Slope Operation

Use Extreme caution when mowing and/or turning on slopes as loss of traction and/or tip-over could occur. The operator is responsible for safe operation on slopes.

DANGER

Operating on wet grass or steep slopes can cause sliding and loss of control. Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning.

Do Not mow slopes when grass is wet.

Do Not mow near drop-offs or near water.

Do Not mow slopes greater than 15 degrees.

Reduce speed and use extreme caution on slopes.

Avoid sudden turns or rapid speed changes.

Keep the roll bar in the raised and locked position and use seat belt.

See inside the back cover to determine the approximate slope angle of the area to be mowed.

Use a walk behind mower and/or a hand trimmer near drop-offs, ditches, steep banks or water. (Figure 3).

Figure 3

1.Safe Zone-Use the mower here on slopes less than 15 degrees

2.Danger Zone-Use a walk behind mower and/or hand trimmer on slopes greater than 15 degrees, near drop-offs and water.

3.Water

Remove or mark obstacles such as rocks, tree limbs, etc. from the mowing area. Tall grass can hide obstacles.

Watch for ditches, holes, rocks, dips and rises that change the operating angle, as rough terrain could overturn the machine.

Avoid sudden stops when mowing downhill because the mower may tip forwards.

Be aware that operating on wet grass, across steep slopes or down hill may cause the mower to lose traction. Loss of traction to the drive wheels may result in sliding and loss of braking and steering.

Always avoid sudden starting or stopping on a slope. If tires lose traction, disengage the blades and proceed slowly off the slope.

Follow the manufacturer’s recommendations for wheel weights or counter weights to improve stability.

Use extreme care with grass catchers or attachments. These can change the stability of the machine and cause loss of control.

Using the Rollover Protection System (ROPS)

A Rollover Protection System (roll bar) is installed on the unit.

8

Image 8
Contents Frontrunnertm California Introduction Contents Safety Safety Alert Symbol Safe Operating Practices TrainingSafety Operation Using the Rollover Protection System Rops Slope OperationMaintenance and Storage Safety Safety and Instructional Decals 109-2355 109-2356 109-2358 109-2377 109-2396 109-7413 116-1003 109-2360 Systems SpecificationsModel Numbers Cutting Deck Hydrostatic Ground Drive SystemTires & Wheels Dimensions Torque RequirementsControls Product OverviewOperation Pre-Start Operating Instructions Raise the Rollover Protection System RopsOpen the Fuel Shut-Off Valve Starting the EngineStopping the Engine Driving the MachineDisengaging the PTO Transporting Transporting a UnitLoading a Unit Maintenance Recommended Maintenance SchedulesCheck Battery Charge Check Engine Oil LevelCheck Safety Interlock System Engine must initiate shutdownCheck Rollover Protections Systems Roll Bar Pins Service Air CleanerCheck Seat Belt Check for Loose HardwareCheck Auxiliary Hydraulic Oil Level Check Tire PressuresCheck Condition Of Belts Lubricate Grease FittingsLubricate Rear Caster Wheel Hubs Pumps PlacesLubricate Motion Control Shaft Lubricate Brake Handle PivotLubricate Brake Rod Bushings Lubricate Motion Control Bronze BushingsFuel Tank Mounting Hardware Specifications Change Hydraulic System FilterCheck Wheel Hub Locknuts Thread Locking AdhesivesPump Drive Belt Replacement Park Brake AdjustmentDielectric Grease Pump Drive Belt TensionMotion Control Linkage Adjustment Weight Transfer Spring Adjustment Caster Pivot Bearings Pre-Load Adjustment Clutch ShimFeeler gauge Brake mounting bolt Cleaning Clean Engine Cooling SystemRemove Engine Shrouds and Clean Cooling Fins Battery DisposalWaste Disposal Motor Oil DisposalTroubleshooting Problem Possible Cause Corrective ActionTroubleshooting Schematics Ignition SwitchIgnition Switch 31HPElectrical Logic Schematic 27HP Kohler Black / Grey Rown BElectrical Logic Schematic 31HP Briggs & Stratton VioletHydraulic Diagram Exmark Commercial Turf Equipment Page Page Service Record Page Page See EXMARK’S Complete Line of Accessories and Options