Exmark MHP4815KC, MHP3614KA, MHP3615KC, MHP3615KA, MHP4816BV manual Pre-Start

Page 22

4.1.7“Off-Run” Switch (B&S and 15 & 17 HP Kawasaki only): Located on the console (Serial No.s 190,000 and higher) or front, left corner of the fuel tank support (Serial No.s 150,000-189,999). Turn key to the “Run” position to allow the engine to be started. Turn key to the “Off” position to shut engine off.

4.1.8Fuel Shut-Off Valve: Installed in the fuel line midway between the tank and the

engine. The fuel shut-off valve is used to shut off the flow of fuel when parking inside a building, during transportation to and from the job sites, and when the machine will not be used for a few days. Rotate valve 1/4 turn clockwise to shut fuel off. Rotatevalve 1/4 turn counter-clockwise to turn fuel on.

4.1.9Transmission Shift Lever:

Located under the control console and behind the fuel tank. It shifts the 5- speed transmission into five forward gears, neutral and reverse. Shift transmission only when drive levers are in the neutral position. Shifting without drivelevers in neutral may cause damage to the transmission.

NOTE: Reverse is “reverse assist” only, meaning when the transmission is in reverse, the operator has to pull the unit backward to “assist” with the movement of the unit.

4.2Pre-Start

DANGER

POTENTIAL HAZARD

In certain conditions gasoline is extremely flammable and highly explosive.

WHAT CAN HAPPEN

A fire or explosion from gasoline can burn you, others, and cause property damage.

HOW TO AVOID THE HAZARD

DO NOT smoke while refueling, and stay away from an open flame or where gasoline fumes may be ignited by spark.

Refuel only in a well ventilated area, or refuel outdoors.

Store gasoline in an approved container and keep it out of the reach of children.

Add fuel before starting the engine. Never remove the cap of the fuel tank or add fuel when engine is running or when the engine is hot.

Never fill the fuel tank so that the gasoline level rises above a level that is 1/2” below the bottom of the filler neck to allow for gasoline expansion and prevent fuel spillage.

If fuel is spilled, DO NOT attempt to start the engine. Move away from the area of the spill and avoid creating any source of ignition until fuel vapors have dissipated.

4.2.1Fill fuel tank. For best results use only clean fresh regular grade unleaded gasoline with an octane rating of 87 or higher. Regular grade leaded gasoline may also be used; however, combustion chamber and cylinder head will require more frequent service. See Engine Owner's Manual.

Do not add oil to gasoline.

- 17 -

Image 22
Contents Page Potential Hazard Exmark Parts PLUS Program Operators Manual Assembly Instructions Table of Contents SafetySpecifications Maintenance & AdjustmentsSafety Alert Symbol SafetyYour Safety is Involved TrainingPotential Hazard Operation Maintenance and Storage Safety Signs Riding AttachmentsPage Page Specifications Wheel Drive System DimensionsTires Torque Requirements Assembly InstructionsUpper Handle Mounting 15 & 17 HP Kawasaki Speed Control Throttle Cable HOOK-UP For Kohler engines Blade Engagement Linkage This Clearance should be Equal Shifter Lever To TransmissionThis Clearance should be Equal Lever and ROD AdjustmentNeutral Lock Lever Clearance Operation Instructions Drive Lever Hardware LocationDrive LEVER, Neutral LOCK/PARK Brake Latch Operation Pre-Start Operating Instructions Potential Hazard Rotating blades under the mower deck are dangerous Periodic Maintenance Maintenance & AdjustmentsTransporting Do not Overfill Blade Bolt Installation Page Grease Lubrication Chart Fitting Initial Quantity Service Locations Pump IntervalSpray Lubricant Chart Pivot PointAdjustments Roller may result Drive Belt Tension Adjustment Positions Mower Cuts Unevenly Trouble ShootingMower Pulling Left or Right Engine will not StartEngine Troubleshooting Table Engine TroubleshootingProblem Wiring Diagram Page Warranty Page Service Record Page Fold Along Appropriate Line See EXMARK’S Complete Line of Products for Turf Care

MHP4815KC, MHP4816BV, MHP3615KA, MHP3615KC, Mhp4816bv, Mhp5216bv, Mhp3614ka, Mhp4814ka, Mhp3615kc, Mhp4815kc, Mhp4817ka, Mhp5217ka, Mhp4815ka, Mhp3615ka specifications

Exmark has long been a leader in the landscaping and turf care industry, and its MHP series of mowers epitomizes dedication to performance, efficiency, and durability. This lineup of models, including MHP4815KC, MHP3615KC, MHP3614KA, MHP4816BV, MHP5216BV, and others, has garnered attention for its innovative features and robust design.

The MHP4815KC and MHP3615KC are equipped with powerful engines, ensuring that they can handle a variety of terrain and grass types with ease. With reliable cutting decks, these machines deliver a clean, precise cut that leaves lawns looking immaculate. Their advanced blade systems are designed for optimal airflow, which enhances cutting efficiency and finish.

The MHP3614KA and MHP4816BV models showcase versatility, allowing users to customize their mowing experience. These mowers come with various deck sizes and cutting heights, providing the flexibility needed for different mowing conditions. The MHP5216BV stands out with its rugged construction, tailored for heavy-duty use, making it an ideal choice for professional landscapers and homeowners with large yards.

Integrated with modern technologies, these mowers are designed for user comfort and ease of operation. The ergonomic design of the handles, combined with padded grips, reduces user fatigue during long mowing sessions. Additionally, many models feature intuitive control systems that allow for easy maneuverability, further enhancing the mowing experience.

Safety is paramount in the MHP series. Many of these models include features such as automatic blade shut-off when the operator leaves the seat, ensuring that accidents are minimised. The robust frame construction also contributes significantly to the durability and longevity of the mowers, standing up well to the rigors of regular use.

In summary, the Exmark MHP series, including models like MHP4815KC, MHP3615KC, MHP3614KA, MHP4816BV, and others, provides top-tier performance, versatility, and safety features. With their powerful engines, advanced cutting technologies, ergonomic designs, and a commitment to user safety, these mowers are truly an investment worth considering for both avid gardeners and professional landscapers alike.