Husqvarna LE389 manual How To Change The Oil, Change Oil

Page 28

Maintenance

How To Change The Oil

Change oil after first 5 to 8 hours of use, then every 50 hours. Change oil every 25 hours when operating the engine under heavy load or in high temperatures.

1Disconnect the spark plug wire and keep it away from the spark plug.

2Clean the area around the oil fill cap (A) and the oil drain plug (B) of dirt and debris. See Figure 27.

3With engine off but still warm, remove the oil drain plug (B). Completely drain all of the oil from the engine into an appropriate receptacle.

4After draining all the oil, install and tighten the oil drain plug.

5Make sure the engine is level.

6Remove the oil fill cap (A) from the engine oil fill

(C).

7To add oil, pour the oil slowly into the engine oil fill. The engine holds approximately 20 ounces (0.6 liter) of oil. For the type of oil to use, see “Oil Recommendation” in the Operation Section.

8Connect the spark plug wire to the spark plug.

C

A

B

C

Figure 27: Change Oil

26	www.usa.husqvarna.com

Image 28

Contents Operator’s Manual − Model LE389 MS-3616MADate of purchase Product model number Serial number Engine modelTable of Contents Safety Symbols And WarningsWhen Adding Fuel When Starting EngineWhen Operating Equipment When Transporting EquipmentBefore performing adjustments or repairs When testing for sparkOperator Safety Rules Before Use Fuel SafetyOperating Safety Safe StorageRepair / Adjustments Safety Parts Packed Separately In Carton Assembly− Wheels − Hardware Parts Bag Removal From The Carton Product Completely AssembledHow To Assemble The Handle Lower HandleAssembly Checklist Handle AssemblyFeatures Before Starting The Engine OperationEye Protection Gasoline Requirements Type of gasoline to useHow To Start The Engine Engine ControlsRecoil Start How To Stop How To Use The Throttle ControlEmergency Stopping Normal StoppingHow To Use The Clutch/Depth Control Lever Thrown debris can cause severe lacerationHow To Use The Index Lever Front Wheel KnobHow To Operate The Edger Operation Of EdgerCurb-hop feature Curb-Hopping FeatureEdging Tips Maintenance Maintenance ChartHow To Remove The Belt Belt RemovalHow To Replace The Blade Blade RemovalEngine Maintenance Carburetor AdjustmentEmission Control Spark PlugHow To Change The Oil Change OilHow To Service The Air Filter Change Air FilterStorage EdgerTroubleshooting Page Product Specifications Power RatingsWarranty Statement Items not Covered by this Warranty Emissions Control System Warranty Statement Owner’s Warranty ResponsibilitiesModerate Engine Mount Assembly Key DescriptionWheel Assembly Model LE389 CURB-HOP Assembly Edger Blade Assembly Blade Guard Assembly Clutch / Drive Lever Assembly Handle Assembly Decals