Husqvarna Z4818BIA, 968999250 manual To Adjust ANTI-SCALP, Rollers See Figure

Page 21

OPERATION

TO ADJUST ANTI-SCALP

ROLLERS (See Figure 6)

Anti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Anti-scalp rollers then keep the deck in the proper position to help prevent scalping in most terrain conditions.

NOTE: Adjust Anti-scalp rollers with the mower on a flat level surface.

•Adjust the deck to the desired cutting height (see “TO ADJUST DECK CUTTING HEIGHT” in the operation section of this manual).

•Using a 3/4" wrench and a 9/16" wrench, remove the nut and shoulder bolt from the anti-scalp roller.

•Lower the anti-scalp roller to the ground, and raise it up to the next highest hole.

•Replace and tighten the nut and shoulder bolt.

•Be sure to adjust all of the anti-scalp rollers to the same position.

•Be sure to readjust the anti-scalp rollers if the cutting height is changed.

IMPORTANT: THE ANTI-SCALP ROLLERS MUST NOT BE USED FOR GAUGE WHEELS OR THE ROLLER AND DECK MAY BE DAMAGED.

1

CZ-9

FIGURE 6

1. ANTI-SCALP ROLLER

21

Image 21

Contents

968999250 / Z4818BIA Operators Manual ModelsGood Service Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Do as follows Driving on SlopesChildren 8011-563 Machine. Activate the parking brake, turn off TransportCustomer Responsibilities SpecificationsTools Required For Assembly AssemblyTo Remove the Mower From Crate Unpack CrateBefore Removing Mower from the Skid Attach Seat See FigAttach Control Levers See Fig Assembly Check the Tire Pressure ChecklistOperation ControlsIZT Integraded Zeroturn TransaxleBYPASS Linkages To SET Parking Brake See Fig HOW to USE Your Mower Deck Blades EngineTo USE Throttle Control See Fig To USE Choke Control See FigTo Move Forward and Backward See Fig CZ-7 To Adjust the Deck Cutting Height See Fig Rollers See Figure To Adjust ANTI-SCALPTo Operate on Hills To Operate MowerTo Transport See Fig Before Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See Fig Mowing Tips Maintenance Schedule Before Each USE General RecommendationsLubrication Chart Operator Presence System TiresBlade Removal See Fig Blade CareTo Sharpen Blade See Fig Belts BatteryLubrication EngineClean AIR INTAKE/COOLING Areas Clean AIR ScreenAIR Filter Engine OIL FilterIN-LINE Fuel Filter See Figs CleaningService and Adjustment MowerTo Level Deck FRONT-TO-BACKADJUSTMENTSee Fig To Replace Deck Belt To Replace IZT Integraded Zeroturn Transaxle Belt See Fig To Adjust the Seat See FigTo Remove Wheels for Repair To Adjust Control Levers See FigTo Attach Jumper Cables To Start AN Engine with a Weak BatteryReplacing Battery See Fig Tracking Adjustment To Adjust Park BrakeStorage BatteryEngine OIL Fuel SystemCylinders OtherProblem Cause Correction Troubleshooting PointsProblemcausecorrection Wiring Schematic