Husqvarna 968999250, Z4818BIA manual FRONT-TO-BACKADJUSTMENTSee Fig

Page 38

SERVICE AND ADJUSTMENT

FRONT-TO-BACKADJUSTMENT(See Fig. 15).

IMPORTANT: DECK MUST BE LEVEL SIDE- TO-SIDE. IF THE FOLLOWING FRONT-TO- BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT OR BOTH REAR LINKAGES EQUALLY SO THE DECK WILL STAY LEVEL.

To obtain the best cutting performance, the deck should be adjusted so the front tip of the blades are approximately 1/8" to 1/4" lower than the rear tip. If the front tip is higher, this will create a poor quality of cut.

WARNING

Blades are sharp. Protect your hands with gloves and/or wrap blades with a heavy cloth when handling.

Check adjustment on the right side of the mower. Position any blade so that the tip is pointing straight forward. Measure distance “B” at the front and rear tip of the blade.

•Before making any necessary adjustments, check to make sure that the deck is level side-to-side.

•With the deck in the highest cutting position, (4 1/2") measure the front tip of the blade to see if the deck is higher or lower than 4 1/2".

•To lower the front tip of the blade, using a 9/16" wrench, loosen the hex nuts that are on the front lift linkages (be sure to loosen equal amounts).

•When distance “B” is 1/8" to 1/4" lower at the front than rear the adjustment is done.

•Reverse above step to raise the deck.

BB

CZ-19

FIGURE 15

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents
Operators Manual Models 968999250 / Z4818BIAGood Service Contents Symbols and Decals General Use Safety InstructionsSafety Instructions Personal protective equipment Driving on Slopes Do as followsChildren 8011-563 Transport Machine. Activate the parking brake, turn offSpecifications Customer ResponsibilitiesTo Remove the Mower From Crate AssemblyTools Required For Assembly Unpack CrateAttach Control Levers See Fig Before Removing Mower from the SkidAttach Seat See Fig Assembly Checklist Check the Tire PressureIZT Integraded Zeroturn TransaxleBYPASS Linkages OperationControls Deck Blades HOW to USE Your MowerTo SET Parking Brake See Fig EngineTo Move Forward and Backward See Fig To USE Throttle Control See FigTo USE Choke Control See Fig CZ-7 To Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Rollers See FigureTo Operate Mower To Operate on HillsTo Transport See Fig ADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See Fig Mowing Tips Maintenance Schedule General Recommendations Before Each USELubrication Chart Tires Operator Presence SystemBlade Care Blade Removal See FigTo Sharpen Blade See Fig Battery Belts Engine LubricationAIR Filter Clean AIR ScreenClean AIR INTAKE/COOLING Areas Engine OIL FilterCleaning IN-LINE Fuel Filter See FigsTo Level Deck Service and AdjustmentMower FRONT-TO-BACKADJUSTMENTSee Fig To Replace Deck Belt To Adjust the Seat See Fig To Replace IZT Integraded Zeroturn Transaxle Belt See FigTo Adjust Control Levers See Fig To Remove Wheels for RepairTo Start AN Engine with a Weak Battery To Attach Jumper CablesReplacing Battery See Fig To Adjust Park Brake Tracking AdjustmentBattery StorageFuel System Engine OILOther CylindersTroubleshooting Points Problem Cause CorrectionProblemcausecorrection Wiring Schematic
Top Page Image Contents