Husqvarna 968999250, Z4818BIA manual Engine, Lubrication

Page 34

CUSTOMER RESPONSIBILITIES

ENGINE

LUBRICATION

Refer to you Engine Owners Manual

TO CHANGE ENGINE OIL (See Fig. 10).

•Be sure the mower is on a level surface.

•Oil will drain more freely when warm.

•Place a suitable container under the right rear corner of the rear of the mower.

•Remove oil dipstick. Be careful not to allow dirt to enter the engine when changing oil.

•Using the clear plastic tube included with you mower, place it over the end of the drain valve located on the right side of your engine.

•Place the other end of the tube thru the 2" diameter hole on the right side of the rear deck.

•Be sure container is located under this area of the mower.

•Using a 10 mm wrench, turn the hex head on the oil valve counter clockwise until the oil is draining out of the tube. After the oil has drained, turn the hex head clockwise until it is tight (do not over tighten).

•Remove the plastic tube from the valve, clean excess oil off of tube and store in a safe place for the next use.

•Refill engine with oil through the oil dipstick tube. Pour slowly. Do not overfill.

•See Engine Owners Manual for type and capacity of the oil.

1

2

CZ-13

FIGURE 10

1.ENGINE OIL DRAIN

2.PLASTIC TUBE

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents
Operators Manual Models 968999250 / Z4818BIAGood Service Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Driving on Slopes Do as followsChildren 8011-563 Transport Machine. Activate the parking brake, turn offSpecifications Customer ResponsibilitiesTo Remove the Mower From Crate AssemblyTools Required For Assembly Unpack CrateAttach Seat See Fig Before Removing Mower from the SkidAttach Control Levers See Fig Assembly Checklist Check the Tire PressureControls OperationIZT Integraded Zeroturn TransaxleBYPASS Linkages Deck Blades HOW to USE Your MowerTo SET Parking Brake See Fig EngineTo USE Choke Control See Fig To USE Throttle Control See FigTo Move Forward and Backward See Fig CZ-7 To Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Rollers See FigureTo Operate Mower To Operate on HillsTo Transport See Fig Check Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See Fig Mowing Tips Maintenance Schedule General Recommendations Before Each USELubrication Chart Tires Operator Presence SystemBlade Care Blade Removal See FigTo Sharpen Blade See Fig Battery BeltsEngine LubricationAIR Filter Clean AIR ScreenClean AIR INTAKE/COOLING Areas Engine OIL FilterCleaning IN-LINE Fuel Filter See FigsMower Service and AdjustmentTo Level Deck FRONT-TO-BACKADJUSTMENTSee Fig To Replace Deck Belt To Adjust the Seat See Fig To Replace IZT Integraded Zeroturn Transaxle Belt See FigTo Adjust Control Levers See Fig To Remove Wheels for RepairTo Start AN Engine with a Weak Battery To Attach Jumper CablesReplacing Battery See Fig To Adjust Park Brake Tracking AdjustmentBattery StorageFuel System Engine OILOther CylindersTroubleshooting Points Problem Cause CorrectionProblemcausecorrection Wiring Schematic
Top Page Image Contents