Husqvarna 968999250, Z4818BIA manual Mowing Tips

Page 26

OPERATION

COLD WEATHER STARTING (50° F and below)

When the engine starts, slowly pull the throttle control back until the engine begins to run smoothly. Continue to pull back on the throttle control in small steps allowing the engine to accept small changes in speed and load, until the throttle control is completely in the fast position. If the engine starts to run roughly, press the throttle control back forward to choke the engine for a few seconds. Then continue to pull the throttle control back slowly to the fast position. This may require an engine warm up period from several seconds to several minutes, depending on the temperature.

MOWING TIPS

The cutting deck should be properly leveled for best mowing performance. See “TO LEVEL DECK” in the Service and Adjustment section of this manual.

The left hand side of the deck should be used for trimming.

Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the mower.

This will result in more even distribution of clippings and a more uniform cut.

If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clippings. Make first cut relatively high; second to desired height.

Do not mow grass when it is wet. Wet grass will plug the deck and leave undesirable clumps. Allow grass to dry before mowing.

Always operate engine at full throttle when mowing to assure better mowing performance and proper discharge of material. Regulate ground speed by going slow enough to allow proper deck cutting performance as well as the quality of cut desired. When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

26

Image 26 Contents
Operators Manual Models 968999250 / Z4818BIAGood Service Contents Symbols and Decals General Use Safety InstructionsSafety Instructions Personal protective equipment Driving on Slopes Do as followsChildren 8011-563 Transport Machine. Activate the parking brake, turn offSpecifications Customer ResponsibilitiesTo Remove the Mower From Crate AssemblyTools Required For Assembly Unpack CrateAttach Control Levers See Fig Before Removing Mower from the SkidAttach Seat See Fig Assembly Checklist Check the Tire PressureIZT Integraded Zeroturn TransaxleBYPASS Linkages OperationControls Deck Blades HOW to USE Your MowerTo SET Parking Brake See Fig EngineTo Move Forward and Backward See Fig To USE Throttle Control See FigTo USE Choke Control See Fig CZ-7 To Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Rollers See Figure To Operate Mower To Operate on HillsTo Transport See Fig ADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See Fig Mowing Tips Maintenance Schedule General Recommendations Before Each USELubrication Chart Tires Operator Presence SystemBlade Care Blade Removal See FigTo Sharpen Blade See Fig Battery BeltsEngine LubricationAIR Filter Clean AIR ScreenClean AIR INTAKE/COOLING Areas Engine OIL FilterCleaning IN-LINE Fuel Filter See FigsTo Level Deck Service and AdjustmentMower FRONT-TO-BACKADJUSTMENTSee Fig To Replace Deck Belt To Adjust the Seat See Fig To Replace IZT Integraded Zeroturn Transaxle Belt See FigTo Adjust Control Levers See Fig To Remove Wheels for RepairTo Start AN Engine with a Weak Battery To Attach Jumper CablesReplacing Battery See Fig To Adjust Park Brake Tracking AdjustmentBattery StorageFuel System Engine OILOther CylindersTroubleshooting Points Problem Cause CorrectionProblemcausecorrection Wiring Schematic