Husqvarna 325RX Assembling and dismantling the two-piece shaft 325RDx, Assembly, Dismantling

Page 13

ASSEMBLY

Assembling and dismantling the two-piece shaft (325RDx)

Assembly

•Loosen the coupling by turning the knob.

•Align the tab of the attachment (A) with the arrow on the coupling (B).

B

A

•Push the attachment into the coupling until the attachment snaps into place.

•Before using the unit, tighten the knob securely.

Dismantling

•Loosen the coupling by turning the knob (at least 3 times).

•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

C

Assembling the cutting equipment

WARNING!

!When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages

!correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting attachment

!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting a blade guard, grass blade and grass cutter

G

F

E

D

A

B

 

C

•Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt.

CAUTION! Use the recommended blade guard. See the Technical data section.

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

1151416-95 Rev. 1 2008-12-23

English – 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 323R 325RX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsStop switch Machine′s safety equipmentThrottle lockout Vibration damping system Cutting attachment guardQuick release MufflerLocking nut Cutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Sharpening the saw bladeFitting the handlebar 323R AssemblyFitting the handlebar 325Rx, 325RDx Assembling and dismantling the two-piece shaft 325RDx AssemblyAssembling the cutting equipment Fitting a blade guard, grass blade and grass cutterFitting a trimmer guard and Superauto II 1 trimmer head Fitting the blade guard and saw bladeFitting other guards and cutting attachments Adjusting the harness and clearing sawStandard harness Fuel Handling Fuel safetyFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingStopping For throttle handles with a start throttle lockWorking Techniques Basic safety rulesGeneral working instructions ABC of clearingWorking methods Forestry clearing using a saw bladeBrush cutting with a saw blade Grass clearing using a grass bladeTrimming Grass trimming with a trimmer headCarburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TAdjusting the start throttle speed High speed jet HCooling system MufflerBevel gear Air filter Cleaning the air filterTwo-piece shaft 325RDx Spark plugMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataTechnical data 325RX 325RDX Engine MANUFACTURER′S Warranty Coverage Federal and California Emissions Control Warranty Statement Super Auto Page S35 095-.106 T35, T35x ´z+SIe¶5S¨ Page 1151416-95 ´z+SIe¶5S¨ ´z+SIe¶5S¨
Top Page Image Contents