Husqvarna 323R, 325RX manual Air filter, Two-piece shaft 325RDx, Spark plug, Cleaning the air filter

Page 27

MAINTENANCE

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

Oiling the air filter

Always use HUSQVARNA filter oil, art. no. 531 00 92-48. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

Two-piece shaft (325RDx)

The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) on models with two-piece shafts will seize if they are not lubricated regularly.

Spark plug

The spark plug condition is influenced by:

Incorrect carburetor adjustment.

An incorrect fuel mixture (too much or incorrect type of oil).

A dirty air filter.

These factors cause deposits on the spark plug electrodes, which may result in operating problems and starting difficulties.

If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0.020 inch (0.5 mm). The spark plug should be replaced after about a month in operation or earlier if necessary.

CAUTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/cylinder.

Note:

Use only HUSQVARNA replacement parts. Use of other brands of replacement parts can cause damage to your unit or injury to the operator or others. Your warranty does not cover damage or liability caused by the use of accessories and/or attachments not specifically recommended by

HUSQVARNA.

1151416-95 Rev. 1 2008-12-23

English – 27

Image 27
Contents 323R 325RX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsMachine′s safety equipment Stop switchThrottle lockout Muffler Cutting attachment guardVibration damping system Quick releaseLocking nut Cutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Sharpening the saw bladeAssembly Fitting the handlebar 323RFitting the handlebar 325Rx, 325RDx Fitting a blade guard, grass blade and grass cutter AssemblyAssembling and dismantling the two-piece shaft 325RDx Assembling the cutting equipmentFitting a trimmer guard and Superauto II 1 trimmer head Fitting the blade guard and saw bladeAdjusting the harness and clearing saw Fitting other guards and cutting attachmentsStandard harness Fuel safety Fuel HandlingFuel Mixing FuelingStarting Starting and StoppingCheck before starting Starting and stoppingStopping For throttle handles with a start throttle lockABC of clearing Basic safety rulesWorking Techniques General working instructionsWorking methods Forestry clearing using a saw bladeBrush cutting with a saw blade Grass clearing using a grass bladeTrimming Grass trimming with a trimmer headCarburetor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburetor Adjusting the start throttle speedMuffler Cooling systemBevel gear Spark plug Cleaning the air filterAir filter Two-piece shaft 325RDxMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataTechnical data 325RX 325RDX Engine MANUFACTURER′S Warranty Coverage Federal and California Emissions Control Warranty Statement Super Auto Page S35 095-.106 T35, T35x ´z+SIe¶5S¨ Page 1151416-95 ´z+SIe¶5S¨ ´z+SIe¶5S¨