Husqvarna 325RX, 323R, 325RDX manual MANUFACTURER′S Warranty Coverage

Page 31

FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and Husqvarna Forest & Garden are pleased to explain the emissions control system’s warranty on your 2009 and later small off-road engine. In U.S. and Canada, new equipment that use small off-road engines must be designed, built, and equipped to meet the applicable Federal or Californian stringent anti-smog standards. Husqvarna Forest & Garden must warrant the emissions control system on your small off- road engine for the period listed below provided there has been no abuse, neglect or improper maintenance of your equipment. Your emissions control system may include parts such as the carburetor, ignition system, catalytic converter, fuel tank, filters and other associated components. Also, included may be hoses, belts, connectors, sensors, and other emission-related assemblies. Where a warrantable condition exists, Husqvarna Forest & Garden will repair your small off- road engine at no cost to you including diagnosis, parts and labor.

MANUFACTURERS WARRANTY

COVERAGE

The emissions control system is warranted for two years. If any emissions-related part on your equipment is defective, the part will be repaired or replaced by Husqvarna Forest & Garden.

OWNERS WARRANTY RESPONSIBILITIES

As the small off-road engine owner, you are responsible for performance of the required maintenance listed in your operator’s manual. Husqvarna Forest & Garden recommends that you retain all receipts covering maintenance on your small off-road engine, but Husqvarna Forest & Garden cannot deny warranty solely for the lack of receipts or your failure to ensure the performance of all scheduled maintenance.

As the small off-road engine owner, you should however be aware that Husqvarna Forest & Garden may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, or improper maintenance or unapproved modifications.

You are responsible for presenting your small off-road engine to a Husqvarna Forest & Garden distribution center or service center as soon as the problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized servicing dealer or call Husqvarna Forest & Garden at 1-800-487-5951 or visit www.usa.husqvarna.com.

WARRANTY COMMENCEMENT DATE

The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser.

LENGTH OF COVERAGE

Husqvarna Forest & Garden warrants to the ultimate purchaser and each subsequent owner that the engine or equipment is designed, built, and equipped so as to conform with all applicable regulations adopted by EPA and CARB, and is free from defects in materials and workmanship that causes the failure of a warranted part for a period of two years.

WHAT IS COVERED

REPAIR OR REPLACEMENT OF PARTS Repair or replacement of any warranted part under the warranty must be performed at no charge to the owner at a warranty station. Warranty services or repairs will be provided at all Husqvarna Forest & Garden distribution centers that are franchised to service the subject engines. Throughout the emissions warranty period of two years, Husqvarna Forest & Garden must maintain a supply of warranted parts sufficient to meet the expected demand for such parts.

WARRANTY PERIOD Any warranted part that is scheduled for replacement as required in the maintenance schedule, is warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part will be repaired or replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under warranty is warranted for the remainder of the period prior to the first scheduled replacement point for the part. Any warranted part that is not scheduled for replacement as required in the maintenance schedule, is warranted for two years. If any such part fails during the period of warranty coverage, it will be repaired and replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under the warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the maintenance schedule will be warranted for a period of two years. A statement in such written instructions to the effect of ”repair or replace as necessary” will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period.

DIAGNOSIS The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact defective, provided that such diagnostic work is performed at a warranty station.

CONSEQUENTIAL DAMAGES Husqvarna Forest & Garden is liable for damages to other engine components proximately caused by a failure under warranty of any warranted part.

EMISSION WARRANTY PARTS LIST

1Carburetor and internal parts

2Intake pipe, airfilter holder and carburetor bolts.

3Airfilter and fuelfilter covered up to maintenance schedule.

4Spark Plug, covered up to maintenance schedule

5Ignition Module

6Muffler with catalytic converter

7Fuel tank

1151416-95 Rev. 1 2008-12-23

English – 31

Image 31
Contents 323R 325RX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsStop switch Machine′s safety equipmentThrottle lockout Muffler Cutting attachment guardVibration damping system Quick releaseLocking nut Cutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Sharpening the saw bladeFitting the handlebar 323R AssemblyFitting the handlebar 325Rx, 325RDx Fitting a blade guard, grass blade and grass cutter AssemblyAssembling and dismantling the two-piece shaft 325RDx Assembling the cutting equipmentFitting a trimmer guard and Superauto II 1 trimmer head Fitting the blade guard and saw bladeFitting other guards and cutting attachments Adjusting the harness and clearing sawStandard harness Fuel Handling Fuel safetyFuel Mixing FuelingStarting Starting and StoppingCheck before starting Starting and stoppingStopping For throttle handles with a start throttle lockABC of clearing Basic safety rulesWorking Techniques General working instructionsWorking methods Forestry clearing using a saw bladeBrush cutting with a saw blade Grass clearing using a grass bladeTrimming Grass trimming with a trimmer headCarburetor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburetor Adjusting the start throttle speedCooling system MufflerBevel gear Spark plug Cleaning the air filterAir filter Two-piece shaft 325RDxMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataTechnical data 325RX 325RDX Engine MANUFACTURER′S Warranty Coverage Federal and California Emissions Control Warranty Statement Super Auto Page S35 095-.106 T35, T35x ´z+SIe¶5S¨ Page 1151416-95 ´z+SIe¶5S¨ ´z+SIe¶5S¨