Husqvarna 325RDX, 323R, 325RX manual Fueling, Mixing

Page 17

FUEL HANDLING

Mixing

•Always mix the gasoline and oil in a clean container intended for fuel.

•Always start by ﬁlling half the amount of the gasoline to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of gasoline.

•Mix (shake) the fuel mixture thoroughly before ﬁlling the machine’s fuel tank.

•Do not mix more than one month’s supply of fuel at a time.

•If the machine is not used for some time the fuel tank should be emptied and cleaned.

WARNING! The catalytic converter mufﬂer

!gets very hot during and after use. This also applies during idling. Be aware of the ﬁre hazard, especially when working near ﬂammable substances and/or vapours.

Fueling

WARNING! Taking the following precautions,

!will lessen the risk of ﬁre:

Do not smoke or place hot objects near fuel.

Always shut off the engine before refuelling.

Always stop the engine and let it cool for a few minutes before refuelling.

When refuelling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refuelling.

Always move the machine away from the refuelling area before starting.

•Clean the area around the fuel cap. Contamination in the tank can cause operating problems.

•Ensure that the fuel is well mixed by shaking the container before ﬁlling the tank.

1151416-95 Rev. 1 2008-12-23

English – 17

Image 17

Contents 323R 325RX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentStop switch Vibration damping system Cutting attachment guardQuick release MufﬂerLocking nut Sharpening grass cutters and grass blades Cutting equipmentCutting equipment Trimmer head Sharpening the saw bladeFitting the handlebar 325Rx, 325RDx AssemblyFitting the handlebar 323R Assembling and dismantling the two-piece shaft 325RDx AssemblyAssembling the cutting equipment Fitting a blade guard, grass blade and grass cutterFitting a trimmer guard and Superauto II 1 trimmer head Fitting the blade guard and saw bladeStandard harness Adjusting the harness and clearing sawFitting other guards and cutting attachments Fuel Fuel safetyFuel Handling Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingStopping For throttle handles with a start throttle lockWorking Techniques Basic safety rulesGeneral working instructions ABC of clearingWorking methods Forestry clearing using a saw bladeBrush cutting with a saw blade Grass clearing using a grass bladeTrimming Grass trimming with a trimmer headCarburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TAdjusting the start throttle speed High speed jet HBevel gear MufﬂerCooling system Air ﬁlter Cleaning the air ﬁlterTwo-piece shaft 325RDx Spark plugMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataTechnical data 325RX 325RDX Engine MANUFACTURER′S Warranty Coverage Federal and California Emissions Control Warranty Statement Super Auto Page S35 095-.106 T35, T35x ´z+SIe¶5S¨ Page 1151416-95 ´z+SIe¶5S¨ ´z+SIe¶5S¨