Husqvarna 220 AC, 230 ACX manual Installation and connecting the charging station

Page 19

3. INSTALLATION

Avoid placing the charging station in a narrow passage (narrower than about 3 metres).

Do not position the charging station so that the mower can come closer than 3 metres behind the charging station (for example on a narrow point). The mower will not then find the charging station.

3012-514

3012-515

3012-744

Installation and connecting the charging station

1.Position the charging station in a suitable spot.

2.Secure the charging station to the ground using the supplied nails.

IMPORTANT INFORMATION

It is not permitted to make new holes in the plate. Only the existing holes may be used to secure the plate to the ground.

3012-549

20 - English

Image 19

Contents Husqvarna Automower 230 ACX/220 AC OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Capacity Function of AutomowerMowing technique Working method 3012-388 3012-700 3012-400 Movement pattern Search methodSearch method 1 Irregular One Automower in several gardens Search method 2 Follow boundary wireSearch method 3 Follow guide wire More than one Automower in a garden Carry out the installation in the following steps InstallationPreparations Installation of the charging stationIdeal position of the charging station Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Installation of the boundary wire Charging the batteryBest position for the boundary wire Boundaries for the working area 30cm10 cm Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire 3012-281 Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire 3012-284 3012-264 3012-265 3012-507 Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryStarting Automower Using the timerStopping Automower Restart after more than 20 seconds Switching off AutomowerRestart Restart within 20 secondsAdjusting the cutting height Control panel Shortcuts Select ProgramsNumbers Main switchNumber series Menu functionsMain menu Browse between menusAutomower main menu Commands TimerTimer CommandsDay timer Timer overrideWeekend timer Garden Week timerMon Tue Wed Thu Fri Sat Sun Run all Exit angles Proportion first Follow loopFollow loop out Distance DirectionProportion Follow loop Corridor width Test OUT TestComplex Garden shapeOpen NormalAdvanced Drive past wireCheck loop Time lock SettingsSecurity PIN codeStop protection Keypad Settings lockSounds OperationSound Significance LanguageTime format Time and dateSet time Set dateGarden example Proposed installation and settings3012-543 3012-544 3012-545 Corridor width Guide 1 This example only applies to 230 ACX 3012-687 Battery MaintenanceAutomower ServiceWinter storage After winter storageChassis CleaningDo not use running water when cleaning Underframe and blade discWheels Replacing the bladesBody 3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Environmental Information Technical dataData Automower 230 ACX Automower 220 AC EU Declaration of Conformity only applies to Europe EU declaration of conformityEU Declaration of Conformity Auto IndexFollow loop Follow loop out Shortcuts Control panel Menus Working area Boundaries 115 03