Husqvarna 230 ACX, 220 AC manual Symbols in the Operator’s Manual

Page 6

1. INTRODUCTION AND SAFETY

1.3Symbols in the Operator’s Manual

These symbols can be found in the Operator’s Manual. Study them carefully so you understand their significance.

•Inspection and/or maintenance must be carried out with the main switch set to OFF.

•Always wear protective gloves when working with the mower’s underframe.

•Never use a high-pressure washer or even running water to clean Automower.

•A warning box indicates a risk of personal injury exist, especially when the stated instructions are not followed.

•An information box indicates a risk of material damage exist, especially when the stated instructions are not followed. The box is also used where there is a risk of user error.

OFF

3012-288

3012-272

3012-271

WARNING

Xxxxxx xxxxx xxxx xxxx xxxxx xxx.

IMPORTANT INFORMATION Xxxxxx xxxxx xxxx xxxx xxxxx xxx.

English - 7

Image 6

Contents Husqvarna Automower 230 ACX/220 AC OPERATOR’S Manual Table of Contents Table of Contents Introduction Safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Safety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toFunction of Automower CapacityMowing technique Working method 3012-388 3012-700 3012-400 Search method Movement patternSearch method 1 Irregular More than one Automower in a garden Search method 2 Follow boundary wireSearch method 3 Follow guide wire One Automower in several gardensInstallation Carry out the installation in the following stepsInstallation of the charging station PreparationsIdeal position of the charging station Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Charging the battery Installation of the boundary wireBest position for the boundary wire 30cm Boundaries for the working area10 cm Boundaries within the working area Secondary areasPassages when mowing Passages when searching for the charging stationSlopes Laying out the boundary wire 3012-281 Laying the boundary wire in towards the charging station Joining the boundary wireConnecting the boundary wire 3012-284 3012-264 3012-265 3012-507 Checking the installation Linking Automower to the charging stationInstallation of the guide wire Need of a guide wirePlacement and connection of the guide wire Maximum 135º Charging a discharged battery UseUsing the timer Starting AutomowerStopping Automower Restart within 20 seconds Switching off AutomowerRestart Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Programs SelectMain switch NumbersBrowse between menus Menu functionsMain menu Number seriesCommands Timer Automower main menuCommands TimerTimer override Day timerWeekend timer Week timer GardenMon Tue Wed Thu Fri Sat Sun Run all Exit angles Follow loop Proportion firstFollow loop out Direction DistanceProportion Follow loop Corridor width Test Test OUTNormal Garden shapeOpen ComplexDrive past wire AdvancedCheck loop PIN code SettingsSecurity Time lockStop protection Operation Settings lockSounds KeypadLanguage Sound SignificanceSet date Time and dateSet time Time formatProposed installation and settings Garden example3012-543 3012-544 3012-545 Corridor width Guide 1 This example only applies to 230 ACX 3012-687 Maintenance BatteryAfter winter storage ServiceWinter storage AutomowerUnderframe and blade disc CleaningDo not use running water when cleaning ChassisReplacing the blades WheelsBody 3012-260 Trouble shooting Fault messagesTrouble Shooting Fault symptom Technical data Environmental InformationData Automower 230 ACX Automower 220 AC EU declaration of conformity EU Declaration of Conformity only applies to EuropeEU Declaration of Conformity Index AutoFollow loop Follow loop out Shortcuts Control panel Menus Working area Boundaries 115 03