Husqvarna 220 AC, 230 ACX manual Connecting the boundary wire

Page 29

3. INSTALLATION

3.5 Connecting the boundary wire

Connect the boundary wire to the charging station:

1.Lift up the cover on the charging station:

•Grip under the edge of the cover with both hands and pull straight out towards the sides.

•Now lift the cover straight up.

2.Slide in the ends of the boundary wire in the lowermost holes on the charging station and catch them in the uppermost holes.

The right hand wire end should be inserted in the right hand hole, and the left hand wire end in the left hand hole.

IMPORTANT INFORMATION

The boundary wire must not be crossed when connecting to the charging station. Therefore the right hand wire end must be connected to the right hand connector on the charging station and vice versa.

3012-268

3012-269

3012-508

3012-506

30 - English

Image 29

Contents Husqvarna Automower 230 ACX/220 AC OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Mowing technique Function of AutomowerCapacity Working method 3012-388 3012-700 3012-400 Search method 1 Irregular Search methodMovement pattern Search method 3 Follow guide wire Search method 2 Follow boundary wireMore than one Automower in a garden One Automower in several gardensCarry out the installation in the following steps InstallationIdeal position of the charging station Installation of the charging stationPreparations Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Best position for the boundary wire Charging the batteryInstallation of the boundary wire Boundaries for the working area 30cm10 cm Secondary areas Boundaries within the working areaSlopes Passages when mowingPassages when searching for the charging station Laying out the boundary wire 3012-281 Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire 3012-284 3012-264 3012-265 3012-507 Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryStopping Automower Using the timerStarting Automower Restart Switching off AutomowerRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Select ProgramsNumbers Main switchMain menu Menu functionsBrowse between menus Number seriesAutomower main menu Commands TimerTimer CommandsWeekend timer Timer overrideDay timer Mon Tue Wed Thu Fri Sat Sun Run all Week timerGarden Exit angles Follow loop out Follow loopProportion first Proportion DirectionDistance Follow loop Corridor width Test OUT TestOpen Garden shapeNormal ComplexCheck loop Drive past wireAdvanced Security SettingsPIN code Time lockStop protection Sounds Settings lockOperation KeypadSound Significance LanguageSet time Time and dateSet date Time formatGarden example Proposed installation and settings3012-543 3012-544 3012-545 Corridor width Guide 1 This example only applies to 230 ACX 3012-687 Battery MaintenanceWinter storage ServiceAfter winter storage AutomowerDo not use running water when cleaning CleaningUnderframe and blade disc ChassisBody Replacing the bladesWheels 3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Data Automower 230 ACX Automower 220 AC Technical dataEnvironmental Information EU Declaration of Conformity only applies to Europe EU declaration of conformityEU Declaration of Conformity Auto IndexFollow loop Follow loop out Shortcuts Control panel Menus Working area Boundaries 115 03