Husqvarna 230 ACX/220 AC manual Installation and connecting the charging station

Page 21

3. INSTALLATION

Installation and connecting the charging station

1.Position the charging station in a suitable spot.

2.Secure the charging station to the ground using the supplied nails.

IMPORTANT INFORMATION

It is not permitted to make new holes in the plate. Only the existing holes may be used to secure the plate to the ground.

3.Connect the low voltage cable to the charging station.

Only use original cable and transformer.

4.Connect the low voltage cable to the transformer.

The connectors may be slightly difficult to connect, as they are moisture-proof.

5.Connect the transformer’s power cord to a 120V wall socket. It is preferable to use an earth-fault breaker as recommended.

IMPORTANT INFORMATION

Do not tread or walk on the charging station plate.

3012-549

3012-263

3012-262

3012-533

22 - English

Image 21
Contents Husqvarna Automower 230 ACX/220 AC OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Function of Automower CapacityMowing technique Working method 3012-388 3012-700 3012-400 Search method Movement patternSearch method 1 Irregular Search method 3 Follow guide wire Search method 2 Follow boundary wireOne Automower in several gardens More than one Automower in a gardenCarry out the installation in the following steps InstallationInstallation of the charging station PreparationsIdeal position of the charging station Transformer is for indoor use only Low voltage cable must not be extended3012-744 Do not tread or walk on the charging station plate Installation and connecting the charging stationCharging the battery Installation of the boundary wireBest position for the boundary wire Boundaries for the working area 3012-459US Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire 3012-284 3012-264 3012-265 3012-507 Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryUsing the timer Starting AutomowerStopping Automower Restart Switching off AutomowerRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Select ProgramsNumbers Main switchMain menu Menu functionsBrowse between menus Number seriesAutomower main menu Commands Timer Garden SettingsTimer CommandsTimer override Day timerWeekend timer Week timer GardenMon Tue Wed Thu Fri Sat Sun Run all Exit angles Follow loop Proportion firstFollow loop out Direction DistanceProportion Follow loop Corridor width Test OUT TestOpen Garden shapeNormal ComplexDrive past wire AdvancedCheck loop Security SettingsPIN code Time lockStop protection Sounds Settings lockOperation KeypadSound Significance LanguageSet time Time and dateSet date Time formatGarden example Proposed installation and settings3012-543 3012-544 3012-545US Corridor width Guide 1 This example only applies to 230 ACX 3012-687US Battery MaintenanceWinter storage ServiceAfter winter storage AutomowerUnderframe and blade disc CleaningReplacing the blades Do not use running water when cleaningChassis Wheels3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Data Automower 230 ACX Automower 220 AC Technical dataSerial number Personal code Dealer Dealer’s telephone number Environmental InformationAuto IndexFollow loop Follow loop out Shortcuts Control panel Menus Working area Boundaries 115 03