Husqvarna 230 ACX/220 AC manual Maximum

Page 35

3. INSTALLATION

The longer the guide wire, the closer the mower follows the guide wire. If the guide wire is longer then 984 ft, the mower may find it difficult to follow the wire. This varies depending on the design of the garden and installation.

2.Lift up the cover on the charging station.

3.If you intend to install guide 1:

•Insert the end of guide 1 into the lower right-hand hole on the charging station and catch it in the upper hole.

•Secure a connector on the guide wire.

•Connect guide 1 to the contact pin on the charging station marked guide 1.

If you intend to install guide 2:

•Insert the end of guide 2 into the lower left-hand hole on the charging station and catch it in the upper hole.

•Secure a connector on the guide wire.

•Connect guide 2 to the contact pin on the charging station marked guide 2.

4.Route the cable straight under the charging station plate.

5.Route the guide wire at least 7 ft straight out from the front edge of the charging plate.

3012-650

3012-538

Maximum

distance

At least 12"

At least

7 ft

3012-648

36 - English

Image 35

Contents Husqvarna Automower 230 ACX/220 AC OPERATOR’S Manual Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Mowing technique Function of AutomowerCapacity Working method 3012-388 3012-700 3012-400 Search method 1 Irregular Search methodMovement pattern Search method 3 Follow guide wire Search method 2 Follow boundary wireOne Automower in several gardens More than one Automower in a gardenCarry out the installation in the following steps InstallationIdeal position of the charging station Installation of the charging stationPreparations Transformer is for indoor use only Low voltage cable must not be extended3012-744 Do not tread or walk on the charging station plate Installation and connecting the charging stationBest position for the boundary wire Charging the batteryInstallation of the boundary wire Boundaries for the working area 3012-459US Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire 3012-284 3012-264 3012-265 3012-507 Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryStopping Automower Using the timerStarting Automower Restart after more than 20 seconds Switching off AutomowerRestart Restart within 20 secondsAdjusting the cutting height Control panel Shortcuts Select ProgramsNumbers Main switchNumber series Menu functionsMain menu Browse between menusAutomower main menu Commands Timer Garden SettingsTimer CommandsWeekend timer Timer overrideDay timer Mon Tue Wed Thu Fri Sat Sun Run all Week timerGarden Exit angles Follow loop out Follow loopProportion first Proportion DirectionDistance Follow loop Corridor width Test OUT TestComplex Garden shapeOpen NormalCheck loop Drive past wireAdvanced Time lock SettingsSecurity PIN codeStop protection Keypad Settings lockSounds OperationSound Significance LanguageTime format Time and dateSet time Set dateGarden example Proposed installation and settings3012-543 3012-544 3012-545US Corridor width Guide 1 This example only applies to 230 ACX 3012-687US Battery MaintenanceAutomower ServiceWinter storage After winter storageUnderframe and blade disc CleaningWheels Do not use running water when cleaningReplacing the blades Chassis3012-260 Fault messages Trouble shootingTrouble Shooting Fault symptom Data Automower 230 ACX Automower 220 AC Technical dataSerial number Personal code Dealer Dealer’s telephone number Environmental InformationAuto IndexFollow loop Follow loop out Shortcuts Control panel Menus Working area Boundaries 115 03