Husqvarna iZ4817SKAA/968999356 manual Roll over Protecion system ROPS, Customer responsibilities

Page 17
Roll over Protecion system ROPS

SAFETY INSTRUCTIONS

Roll over Protecion system ROPS

The ROPS increases the basic weight of the unit by 42 lbs/19 kg. The ROPS on the US units are standard, on the European units is the ROPS an accessory.

WARNING!

The structures capability may be imparired by structural damage if overturned, or alteration occurs. If any of these conditions take place, the total structure MUST be replaced.

Do not use ROPS as a lifting, attaching or anchoring point.

Do not use ROPS for wrecking or towing.

Do not exceed Max GVW: 2822 lbs/1283 kg.

Read machine operator´s manual before each use.

Securely fasten your seat belt if the unit has a ROPS.

Where possible, avoid operating the unit near ditches, embankments and holes.

Reduce speed when turning, crossing slopes and on rough, slick or muddy surfaces.

Stay off slopes too steep for safe operation.

Watch where you are going, especially at row ends, on roads and around trees.

Do not permit others to ride.

Operate the mower smoothly - no jerky turns, starts or stops.

When mower is stopped, set brakes securely and use park brake.

If any part of ROPS is damaged, the entire ROPS must be replaced.

Check all bolts including seat belt for correct torque before each use.

Check ROPS structure for damage before each use.

ROPS bar is NOT intended for use in sub zero temperatures.

Customer responsibilities

Read and observe the safety rules.

Follow a regular schedule in maintaining, caring for and using your mower.

Follow the instructions under "Maintenance” and "Storage” sections of this owner’s manual.

This machine has no brain. Use yours!

WARNING!

This mower is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, bush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffler is available through your authorized Husqvarna dealer.

English-15

Image 17
Contents English Operator´s manualPage OPERATOR’S MANUAL RIDER iZ SERIES ContentsEnglish-2 Introduction INTRODUCTIONCongratulations GeneralManufacturing Number Good ServiceSymbols and Decals SYMBOLS AND DECALSXxxxxxx xxxx xxxxxxxx xxx Xxxxx xxxxxx xx xxxxxxxx xxxxx xxx xxxx xxxxxxRead General Operation SAFETY INSTRUCTIONSSafety Instructions Operate machine only in daylight or good artificial light Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline MaintenanceThe engine and the exhaust system, become very hot during operation Risk for burns if touchedAlways use protective glasses when handling the battery General MaintenanceEnglish-13 Risk of sparkingIMPORTANT INFORMATION TransportCustomer responsibilities Roll over Protecion system ROPSControl Locations CONTROLSControls 1 Forward 2 Neutral 3 Neutral slot, Neutral lock 4 Reverse 1. Motion Control Levers4. Parking Brake 2. Hour Meter3. Tracking Knob 7. Fuses 5. Blade switch6. Ignition Switch 8. Seat Locking Device see the safety rules9. Refueling allow engine and exhaust system to cool at least two 2 minutes12. Choke Control 11. Seat Adjustment Lever10. Fuel Shut Off Valve 14. Lifting Lever for the Mower Deck 13. Throttle ControlThrottle control The mower deck’s lifting leverPump release valves AccessoriesCutting height pedal Only rotate valve 1/4 - 1/2 turn to release systemOperation OPERATIONTraining To move forward and backwardThe seat belt must be used when the roll bar is in upright position Roll bar and safety beltBefore Starting Starting the EngineSteering controls in the outward, locked neutral position Depress the control for disengaging the mower deckSet the throttle English-26Open the fuel valve Set the choke controlTurn to the start position English-27IMPORTANT INFORMATION Do not run the starter for more than USE FULL THROTTLE WHEN MOWINGTo remove cables, reverse order To start an engine with a weak batteryTo attach jumper cables Running The mower deck’s anti-scalp rollers shall be evenly adjustedEnsure that no one is near the machine when engaging the blade switch English-31 Operating on hillsMowing Tips Stopping the Engine Moving by Hand No adjustments or maintenance to carried out unlessthe engine is stopped the ignition key has been removed the parking brake is onMaintenance Schedule MAINTENANCEMaintenance English-36 To clean battery and terminals BatteryReplacing battery Always use two wrenches for the terminal screwsFitting the wrong spark plug type can damage the engine Ignition SystemChecking the Safety System Ignition system Safety systemEnglish-40 8011-553Checking the Engines Cooling Air Intake Checking and Adjusting the Throttle CableChecking and Adjusting the Choke Cable Replacing the Air Filter Do not used compressed air to clean the air filterStandard air filter Do not wash the paper filter. Do not oil the paper filterDo not wash the paper filter. Do not oil the paper filter Dust cap Cyclon air filter maintenance1. Remove the end cover Filter replacementAir filter indicator optional Checking the Fuel Pump’s Air Filter Replacing the Fuel FilterChecking Tire Pressures Faulty adjustment can cause an accidentChecking the Parking Brake Checking the V-beltsPump belt Checking the BladesRemove blade bolt by turning counterclockwise Blade replacementDo not use lower grade hardware than specified Before performing any service or adjustment checklist Adjusting the Mower Deck2. Place the blade-switch in the disengaged position 3. Turn ignition switch to “OFF” position and remove the keyEngine oil cooler Adjust Anti-scalp rollers with the mower on a flat level surfaceTo adjust anti-scalp rollers Use protective glasses when cleaning and washing Cleaning and WashingRemoval and installation of caster wheel Caster WheelsLubrication Schedule LUBRICATIONLubrication Shaft Bushings and Linkage Lubricating the CablesLubricating in Accordance with the Lubrication Schedule 1. Hydraulic System, Oil LevelAvoid skin contact wash with soap and water in case of spills 3. Engine Oil Kohler Engine Changing the Engine OilCheck oil before each use as follows Checking the Oil LevelOil Type Oil Recommendations3. Engine Oil Kawasaki Engine Changing the Engine Oil 5. Front Wheel Mount 4. Throttle and Choke Cables, Lever Bearings6. Front Wheel Bearings 8. Mower Deck Height Adjuster7. Deck belt pulleys Lubricating the cutting height adjuster11. Mower Deck Struts 9. Belt Adjuster, Mower Deck10. Steering Control Shafts Tip the driver’s seat 12. Brake Arms 13. Belt Adjuster, Hydraulic Pumps14. Changing the Oil Filter Trouble Shooting Guide TROUBLE SHOOTING GUIDEProblem CauseEnglish-64 STORAGE ServiceStorage Winter StorageWiring diagrams WIRING DIAGRAMSTechnical Data TECHNICAL DATAiZ4819TSKAA iZ5221TKAAEquipment Overall dimensionsProductivity English-68iZ5224TLKOA iZ5225TXPKOAiZ6125TKOA English-69English-70 iZ4817TSKAA iZ4217TSKAAiZ4821TKAA Dual levers, foam grippedEnglish-72 English-73 iZ5223TKOAEnglish-74 English-75 Torque SpecificationsUSA requirements CONFORMITY CERTIFICATESConformity Certificates Service Journal SERVICE JOURNALDelivery Service ActionAfter the First 8 Hours English-79 25-Hour ServiceEnglish-80 50-Hour Service100-Hour Service 300-Hour Service At Least Once Each Year 112673R0112/05/05