Husqvarna EZ6124, EZ5226, EZ4822, EZ4621, EZ4220 manual Refueling

Page 20

CONTROLS

5. Refueling

Read the safety instructions before refueling. The machine has one fuel tank, just behind the seat. The tank volume is 5.4 gallons

(20.4 liters).

Make sure the fuel cap is properly tightened and the cap gasket is not damaged.

The engine will run on a minimum of 85-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used beneficially. See also Technical Data concerning ethanol fuel. Methanol fuel is not allowed.

WARNING!

Gasoline is highly flammable. Observe caution and fill the tank outdoors (see the safety instruction).

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before refueling

WARNING!

Fill to bottom of filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

When operating in temperatures below 32° F. (0° C.), use fresh, clean winter grade gasoline to help insure good cold weather starting.

8011-761

Fuel tank

IMPORTANT INFORMATION

Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel the next season. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur.

English-21

Image 20
Contents Operator’s Manual EnglishContents OPERATOR’S ManualPage Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx Xxxxxxxxx xxxxxx Xx xxxxxxxx xxxxRead General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline MaintenanceGeneral Maintenance Never drive the machine in an enclosed space Risk of sparking Transport Customer responsibilities Controls ControlsParking Brake Steering Control LeversTracking Seat adjustment boltsFuel Shut Off Valve Refueling By pass linkage FusesChoke Control Ignition SwitchHour Meter Blade switch Throttle ControlAccessories Cutting height pedalOperation OperationTraining To move forward and backwardBefore Starting Starting the EngineMove the throttle to the middle position Open the fuel shut off valve Gradually press in the choke control To remove cables, reverse order To start an engine with a weak batteryTo attach jumper cables Running Operating on hills Mowing Tips Stopping the EngineLeaving the ignition switch in any other Moving by Hand Maintenance Schedule MaintenanceMaintenance English-38 Replacing battery BatteryTo clean battery and terminals Checking the Safety System Ignition SystemChecking the Engine’s Cooling Air Intake Checking and Adjusting the Throttle CableChecking and Adjusting the Choke Cable Replacing the Air Filter Briggs & Stratton Engine Standard air filterReplacing the Air Filter Kohler Engine Servicing PrecleanerService Paper Element Replacing Heavy Duty Air Filter Checking Tire Pressures Replacing the Fuel FilterChecking the Fuel Pump’s Air Filter Checking the Parking Brake Checking the V-beltsDeck belt To replace deck beltDeck belt installation Belt installation IZT beltTo replace IZT Integraded Zeroturn Transaxle belt IZT belt removalChecking the Blades Blade replacement Leveling Adjusting the Mower DeckAdjusting Cutting Height To adjust anti-scalp rollers Cleaning and Washing Removal and installation of caster wheelCaster Wheels HardwareTracking adjustment To adjust parking brakeMower is tracking to the right Mower is tracking to the leftLubrication LubricationGeneral Lubrication ScheduleLubricating the Cables Lubricating in Accordance with the Lubrication ScheduleFront Wheel Mount Front Wheel BearingsDeck outer spindle Engine Oil Changing the Engine OilChecking the Oil Level Changing the Engine Oil Filter Transaxle Transmission Fluid ChangeDrain old oil filters of all free flowing oil prior to Purging Procedures Problem Cause Trouble Shooting GuideTrouble Shooting Guide English-63 English-64 Service StorageStorage Winter StorageWiring Diagram Technical Data Technical DataEZ4624 EZ5226 Engine TransmissionTechnical Data EZ4624 EZ5226 Equipment EZ4220 EZ4822 Engine EZ 4220 EZ4822 Equipment Technical Data Productivity Conformity Certificates Conformity CertificatesUSA requirements CE requirementsService Journal Service JournalDelivery Service Action Date, mtr reading, stamp, signAfter the First 5-8 Hours Hour Service English-78 English-79 Service Journal At Least Once Each Year Service Journal Page Page Part No 131329Rir 07/02/07