Husqvarna EZ6124, EZ5226, EZ4822 To start an engine with a weak battery, To attach jumper cables

OPERATION

To start an engine with a weak battery
WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks,
flame and smoking materials
away from batteries. Always
wear eye protection then around
batteries.
If your battery is too weak to start the engine, it should
be recharged. (See “Battery” in the Maintenance
Section.)
IMPORTANT INFORMATION
Your mower is equipped with a 12-volt
negative grounded system. The other
vehicle must also be a 12-volt negative
grounded system. Do not use your mower
to start other vehicles.
If “jumper cables” are used for emergency starting,
follow this procedure:	8011-642
To attach jumper cables	Jumper cable connection

•Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

•Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

•Remove BLACK cable first from chassis and then from the fully charged battery.

•Remove RED cable last from both batteries.

English-31