Remote control (continued)
Test of the remote control
Point the remote control directly at the remote sensor on the sound bar.
The remote control can be used within the range shown below:
Remote sensor
0.2 m - 6 m
15° 15°
General control
Make sure to enable the HDMI CEC when making HDMI connection. For details, refer to the operation manual of the TV.
To turn the power on
Press the ON/STANDBY button on the sound bar or the remote control.
The power turns on and the subwoofer indicator turns blue. If the power does not turn on, check whether the AC power lead is plugged in properly.
The system will automatically power on if TV or similar component which supports HDMI CEC, is turned on.
To set the sound bar to standby mode:
Press the ON/STANDBY button again on the sound bar or the remote control and the subwoofer indicator turns red.
Notes:
A slight audio delay after TV is turned ON does not mean that the system is faulty. This is normal.
“AQUOS speaker is enabled” message will be displayed if SHARP LCD TV does not detect
Standby mode
The fi rst time the unit is plugged in, it will enter the STANDBY mode.
To cancel the STANDBY mode, press and hold the ECO MODE button (remote control) during power standby mode. The unit will enter the low power consumption mode.
To return to the STANDBY mode, press the ECO MODE button again.
During STANDBY condition, NFC function is activated once your device touches the supplied NFC tag when there is no HDMI connection.
Connecting the wireless Subwoofer
The sound bar and subwoofer will link automatically (wirelessly) when turned on as it is already
1.Press and hold the PAIRING button on the sound bar or SW LINK on the remote control for more than 3 seconds.
2.Within 2 minutes, press and hold the SW LINK button on the subwoofer for more than 3 seconds.
During pairing process:
On sound bar: “SW LINK” will blink.
On subwoofer: indicator will blink in blue.
When pairing is successful:
On sound bar: “SW LINK” disappears.
On subwoofer: indicator turns blue.
SW LINK
Sound Bar | Remote | Subwoofer |
| Control |
|
Notes:
If a device such as microwave oven, wireless LAN card, Bluetooth device or any other device that uses the same 2.4GHz frequency near the system, some sound interruption may be heard due to interference.
The transmission distance of the wireless signal between the subwoofer and sound bar is about 10m (32 feet), but may vary depending on your operating environment. If a
Caution:
Keep the subwoofer away from water and moisture.
To get the optimum listening performance, make sure the area around the sound bar and subwoofer is clear of any obstacles.
