Operating the TV with the remote control
You can operate Sharp TVs with this system’s remote control.
Watching TV
Point the remote control at the TV.
1Press the TV ( ) ON/STANDBY button to turn on the TV.
2Pressing the TV CH + or – button enables TV channel switching.
3Press the TV VOL + or – button to adjust the TV volume.
Other operable button
Input Select Button
Mute (TV)
AV mode
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service technician.
If something is wrong with this product, check the following before calling your authorized SHARP dealer or service centre.
General
Symptom | Possible cause |
|
|
No sound is heard. | Is the input signal (selection) set |
| properly? |
| Is the volume level set to “MIN”? |
| Is muting activated? |
| Is HDMI compliant equipment |
| being used? |
| Is the HDMI cable connected |
| correctly? |
| Connect the HDMI cable correctly |
| and then perform the reset |
| procedure. (refer page 18) |
| Do not connect or disconnect |
| an HDMI cable whilst power is |
| on. This may lead to operation |
| problems. |
The sound from | Is the subwoofer level set to the |
subwoofer is not | minimum or maximum level? |
well balanced. |
|
Power turns off | Is the HDMI cable connected |
suddenly. | correctly? Connect the HDMI |
| cable correctly and then perform |
| the reset procedure. |
|
|
Noise is heard | Move the speaker away from any |
during playback. | computers or mobile phones. |
|
|
When a button | Set the sound bar to the standby |
is pressed, the | mode and then turn it back on. |
sound bar does not |
|
respond. |
|
The power is not | Is the sound bar unplugged? |
turned on. | The protection circuit may be |
| activated. Unplug and plug in the |
| power lead again after 5 minutes |
| or more. |
|
|
3D images not | Depending on the TV and Video |
displayed on the | component, 3D images may not |
TV. | be displayed. |
| Check the operation manual of the |
| respective component. |
| HDMI cable not support 3D image. |
|
|
Background noise | Please change to HDMI/ARC or |
appears when | headphone terminal from |
connecting with | |
RCA audio output | effect may occur depending on |
terminal connection | |
from a | Brand, model and age, and it is |
not the sound bar problem. | |
Player. |
|
Wireless | Check the distance between the |
connection cannot | sound bar and subwoofer (less |
be established. | than 10m (32 feet)). |
| Make sure there is no other |
| wireless devices near the unit. |
|
|