Sound bar preparation
To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar 3.7 kg from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The sound bar may fall.) If unsure, consult a qualified service technician.
Mounting screws are not supplied. Use appropriate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur or the sound bar may get damaged.
SHARP is not responsible for accidents resulting from improper installation.
Driving screws
SHARP designed the sound bar so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.
3.2 mm
5 mm
9 mm
Min. 22 mm
Fixing wall mount angle (Horizontal position)
1Fix the pattern paper to the wall in horizontal position as below.
926 mm | 44 mm |
| |
Wall surface 44 mm | 29 mm |
| |
29 mm | Pattern paper |
|
2Make a hole on the wall following the screw point marks on the pattern paper by using a
drill.
32 mm
Wall surface
3Fix a wall mount plug (not supplied) into the hole using a hammer, until it is flush with the
wall surface.
32 mm
Wall surface
4Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 8 pieces)
Wall mount angle |
|
|
Wall mount |
|
|
angle | Wall | Wall |
(screws x 4) | surface | mount |
Wall surface |
| angle |
|
| |
(screws x 4) |
|
|
Wall surface |
| |
Note:
Make sure all screws are fully tightened. (screws are not supplied)
Installing the sound bar
1Align the wall mount slot at the sound bar to the wall mount angle.
2Slot the sound bar into the wall mount angle.
3Fix them securely.
Wall surface
