6-17
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter6 Configuring IEEE 802 .1x Port-Based Authentication
Configuring IEEE 802.1x Authentication
To disable periodic re-authentication, use the no dot1x reauthentication interface configuration
command. To return to the default number of seconds between re-authentication attempts, use the no
dot1x timeout reauth-period global configuration command.
This example shows how to enable periodic re-authentication and set the number of seconds between
re-authentication attempts to 4000:
Switch(config-if)# dot1x reauthentication
Switch(config-if)# dot1x timeout reauth-period 4000
Manually Re-Authenticating a Client Connected to a PortYou can manually re-authenticate the client connected to a specific port at any time by entering the
dot1x re-authenticate interface interface-id privileged EXEC command. This step is optional. If you
want to enable or disable periodic re-authentication, see the “Enabling Periodic Re-Authentication”
section on page 6-16.
This example shows how to manually re-authenticate the client conne cted to a port:
Switch# dot1x re-authenticate interface gigabitethernet0/17
Changing the Quiet PeriodWhen the switch cannot authenticate the client, the switch remains idle for a set period of time, and then
tries again. The idle time is determined by the quiet-period value. A failed authentication of the client
might occur because the client provided an invalid password. You can provide a faster response time to
the user by entering a smaller number than the default.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Specify the interface to be configured, and enter interface configuration
mode.
Step3 dot1x reauthentication Enable periodic re-authentication of the client, whi ch is disabled by
default.
Step4 dot1x timeout reauth-period {seconds |
server}
The keywords have these meanings:
•seconds—Sets the number of seconds from 1 to 65535; the default is
3600 seconds.
•server—Sets the number of seconds as the value of the
Session-Timeout RADIUS attribute (Attribute[27]). You can use this
keyword when the switch uses IEEE 802.1x authentication with a
RADIUS server.
This command affects the behavior of the switch only if periodic
re-authentication is enabled.
Step5 end Return to privileged EXEC mode.
Step6 show dot1x interface interface-id Verify your entries.
Step7 copy running-config startup-config (Optional) Save your entries in the configuration file.