13-4
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBMBladeCenter, Software Configuration Guide
24R9746
Chapter13 Configuring VTP
Understanding VTP
VTP advertisements distribute this global domain information:
•VTP domain name
•VTP configuration revision number
•Update identity and update timestamp
•MD5 digest VLAN configuration, including maximum transmission unit (MTU) size for each
VLAN.
•Frame format
VTP advertisements distribute this VLAN information for each configured VLAN:
•VLAN IDs
•VLAN name
•VLAN type
•VLAN state
•Additional VLAN configuration information specific to the VLAN type
VTP Version 2If you use VTP in your network, you must decide whether to use version 1 or version 2. By default, VTP
operates in version 1.
VTP version 2 supports these features not supported in version 1:
•Token Ring support—VTP version 2 supports Token Ring Bridge Relay Function (TrBRF) and
Token Ring Concentrator Relay Function (TrCRF) VLANs. For more information about Token
Ring VLANs, see the “Configuring Normal-Range VLANs” section on page 12-4.
•Unrecognized Type-Length-Value (TLV) support—A VTP server or client propagates
configuration changes to its other trunks, even for TLVs it is not able to parse. The unrecognized
TLV is saved in NVRAM when the switch is operating in VTP server mode.
•Version-Dependent Transparent Mode—In VTP version1, a VTP transparent switch inspects VTP
messages for the domain name and version and forwards a message only if t he version and domain
name match. Because VTP version 2 supports only one domain, it forwards VTP messages in
transparent mode without inspecting the version and domain name.
•Consistency Checks—In VTP version 2, VLAN consistency checks (such as VLAN names and
values) are performed only when you enter new information through the CLI or SNMP. Consistency
checks are not performed when new information is obtained f rom a VTP message or when
information is read from NVRAM. If the MD5 digest on a received VTP message is correct, its
information is accepted.
VTP PruningVTP pruning increases network available bandwidth by restricting flooded traffic to those trunk links
that the traffic must use to reach the destination devices. Without VTP pruning, a switch floods
broadcast, multicast, and unknown unicast traffic across all trunk links within a VTP domain even
though receiving switches might discard them. VTP pruning is disabled by default.