IBM 12.1(22)EA6 Displaying SPAN and RSPAN Status

18-17
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter18 Configuring SPAN and RSPAN
Displaying SPAN and RSPAN Status
Displaying SPAN and RSPAN Status
To display the status of the current SPAN or RSPAN configuration, use the show monitor privileged
EXEC command.
This is an example of output for the show monitor privileged EXEC command for SPAN source
session 1:
Switch# show monitor session 1
Session 1
---------
Type : Local Session
Source Ports :
RX Only : None
TX Only : None
Both : Fa0/4
Source VLANs :
RX Only : None
TX Only : None
Both : None
Source RSPAN VLAN : None
Destination Ports : Fa0/5
Encapsulation: DOT1Q
Ingress: Enabled, default VLAN = 5
Reflector Port : None
Filter VLANs : None
Dest RSPAN VLAN : None