IBM 12.1(22)EA6 Configuring the DSCP-to-CoS Map

23-33
Cisco Systems IntelligentGigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter23 Configuring QoS
Configuring Standard QoS
Configuring the DSCP-to-CoS Map
You use the DSCP-to-CoS map to map DSCP values in incoming packets to a CoS value, which is used
to select one of the four egress queues.
The switch supports these DSCP values: 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46, 48, and 56.
Table23-8 shows the default DSCP-to-CoS map.
If these values are not appropriate for your network, you need to modify them.
Beginning in privileged EXEC mode, follow these steps to modify the DSCP-to-CoS map:
To return to the default map, use the no mls qos map dscp-cos global configuration command.
Table23-8 Default DSCP-to-CoS Map
DSCP Values CoS Value
00
8, 10 1
16, 18 2
24, 26 3
32, 34 4
40, 46 5
48 6
56 7
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 mls qos map dscp-cos dscp-list to cos Modify the DSCP-to-CoS map.
For dscp-list, enter up to 13 DSCP values separated by spaces. Then enter
the to keyword.
For cos, enter the CoS value to which the DSCP values correspond.
The supported DSCP values are 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46 , 48,
and 56. The CoS range is 0 to 7.
Step3 end Return to privileged EXEC mode.
Step4 show mls qos maps dscp-cos Verify your entries.
Step5 copy running-config startup-config (Optional) Save your entries in the configuration file.