5 ADVANCED CONFIGURATION

Advanced Configuration Parameter Default Values

To change advanced configuration parameter values, you will need terminal emulation software to allow you to use AT commands.

For Windows 95 and Windows NT users, HyperTerminal terminal emulation software is provided with those operating systems. For Macintosh users, terminal emulation software was installed in the 3ComImpact IQ folder during software installation.

The advanced configuration parameters and their default settings are as follows:

Auto Answer (disabled)

Baud Rate (automatic detection of rates up to 115.2 Kbps)

Compression (enabled)

Dynamic Bandwidth Allocation (enabled)

QuickSelect (enabled)

Each parameter is described in detail in the following section. If the default settings meet your preferences, go on to Chapter 6,“Placing and Receiving Calls.”

Page 61
Image 61
3Com 3C882 manual Advanced Configuration, Advanced Configuration Parameter Default Values