set igmp qi 531
set igmp qi Changes the IGMP query interval timer on one VLAN or all VLANs on a
WX.
Syntax — set igmp qi seconds [vlan vlan-id]
qi seconds — Number of seconds that elapse between general
queries sent by the WX when the WX switch is the querier for the
subnet. You can specify a value from 1 through 65,535.
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default query interval is 125 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The query interval is applicable only when the WX is querier for
the subnet. For the WX switch to become the querier, the pseudo-querier
feature must be enabled on the WX and the WX must have the lowest IP
address among all the WX switches eligible to become a querier. To
enable the pseudo-querier feature, use the set igmp querier command.
Examples — The following command changes the query interval on
VLAN orange to 100 seconds:
WX1200# set igmp qi 100 vlan orange
success: change accepted.
See Also
set igmp lmqi on page 526
set igmp oqi on page 529
set igmp qri on page 532
set igmp querier on page 533
set igmp mrouter on page 527
set igmp rv on page 534