470 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
beacon-rate:
11a—6.0
11b—2.0
11g—2.0
multicast-rate—auto for all radio types.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — If you disable a rate, you cannot use the rate as a mandatory
rate or the beacon or multicast rate. All rates that are applicable to the
radio type and that are not disabled are supported by the radio.
Examples — The following command sets 802.11a mandatory rates for
service profile sp1 to 6 Mbps and 9 Mbps, disables rates 48 Mbps and
54 Mbps, and changes the beacon rate to 9 Mbps:
WX4400# se t service-profile sp1 transmit-rates 11a mandatory
6.0,9.0 disabled 48.0,54.0 beacon-rate 9.0
success: change accepted.
See Also
display service-profile on page 353
set service-profile
use-client-dscp
Configures MSS to classify the QoS level of IP packets based on their
DSCP value, instead of their 802.11 priority.
Syntax — set service-profile name user-client-dscp
{enable |disable}
name — Service profile name.
enabled — Enables mapping QoS level from the DSCP level.
disabled — Disables mapping QoS level from the DSCP level.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 6.0.