3M 2100 manual Post should Fold Down Without TOO Much Force

MODEL 2100 OVERHEAD PROJECTOR

POST (FOLDING)

If POST is not perpendicular to the body of the projector, proceed with the following steps using Figures below as reference:

1.Loosen SET SCREW.

2.Put a square on the body of the projector and against the POST>

3.Turn the CAM clockwise to adjust POST.

4.Re-tighten SET SCREW.

NOTE

POST SHOULD FOLD DOWN

WITHOUT TOO MUCH FORCE.

3.Bend down the appropriate LOCKING TAB.

LAMPCHANGER CABLE

NOTE

Tension on cable should be a maximum of 3/16".

A.Hold the Cable Nuts (2) with wrench and loosen the Cable Screws (2).

B.Move the screws with nuts outward to tighten cable.

C.Retighten screws with nuts after adjustment is made. (See Figure)

Before Serial Number 422868

On projectors after serial number 422868, there is no cable adjustment.

4-6 9/92