17.11Polish 10
Note: Do not hold polishing jig assembly by the weight when polishing. Hold only by the textured polishing adapter.
Note: Because bead is 3 to 4 times smaller than classic hot melt connectors you will not feel the bead of adhesive being removed as you polish.
IMPORTANT: Make sure that polishing jig stays flat on lapping film at all times
17.12After bead of adhesive is no longer visible, polish an additional 5 strokes.
17.13Remove the connector from the polishing jig assembly and clean the connector endface with a
17.14Inspect the connector endface with the 200X Westover™ Scientific fiber view scope. Use the thumb toggle switch to activate the light onto the fiber end face. There are two light
20 |
|
