3M 6700-50 SC 50 m MM 250/900 m, 8700-UPC manual Connector and Protrusion Setting Tool Preparation

1.3Additional materials needed:

•De-ionized or distilled water for nano-finishing at above-freezing temperatures

•25% to 35% methanol by volume and 75% to

65% de-ionized or distilled water solution by volume for nano-finishing at below-freezing temperatures. DO NOT use ethanol or isopropyl alcohol for nano-finishing.

•99% pure isopropyl alcohol (for cleaning only) or a fiber optic connector cleaning solution approved by your company.

Note: Carefully follow safety, health and environmental information given on product labels or the Material Safety Data Sheets for isopropyl alcohol, fiber optic cleaning fluid, and/or methanol/water solution.

1.4Optional accessory:

3M™ 200X View Scope 6365-VS. DO NOT use when connectors are illuminated by a laser source.

2.0Connector and Protrusion Setting Tool Preparation

2.1On the 3M™ Protrusion Setting Tool, move the

actuator lever to the unactivated position as shown.

2.2Clean the tip of the protrusion setting jig using a lint-free cleaning swab with a drop of alcohol or cleaning fluid. Reach through the window with the swab and move the swap tip vertically to clean the jig tip.

wipe jig tip with vertical motion

4 78-0013-1746-6-E