Manuals / Brands / Computer Equipment / Computer Monitor / 3M / Computer Equipment / Computer Monitor

3M EX II 3000SP EX II 3000SP Controller, Communications, Controller Default Settings, Communication Parameters, CHAPTER

1 34

Download 34 pages, 215.76 Kb

CHAPTER 2

EX II 3000SP Controller

Communications

This chapter discusses the fundamentals of communicating with the EX II 3000SP controller. Firmware commands are usually issued by a driver or utility program on the host system, however developers can enter these commands directly.

This chapter:

•Describes the controller default settings

•Lists the recommended firmware commands for current development

•Describes how to use each of these commands

•References additional commands developers may need

The description of each command includes the command syntax, the default value, how the command works, and the expected response from the controller.

Controller Default Settings

This section describes the default communications parameters, data format, and operating mode settings for the EX II 3000SP controller.

Communication Parameters

The default operation of the EX II 3000SP controller is N, 8, 1 (no parity, 8 data bits, and 1 stop bits) at 9600 baud. It also can be programmed to work with even/odd parity, 8 data bits, and 1 or 2 stop bits.

3M Touch Systems Proprietary Information

Contents

Page Page Contents Appendix A EX II 3000SP Controller Specifications About This Manual What You Need to Know Important Safety Information Explanation of Symbols 3M Touch Systems Support Services 3M Touch Systems Worldwide Offices Page CHAPTER Integrating the EX II 3000SP Controller Overview of the EX II 3000SP Touch Screen Controller Figure 1 Components of the TouchPen System Note: Establishing the Data Connection Mounting the Controller Supplying Power to the Controller Using a Custom Serial Cable Design Mounting the Touch Screen Handling and ESD Protection Turning On Your System Status Light (LED) Diagnostics What's Next Installing and Using TouchWare Calibrating the Touch Screen Page EX II 3000SP Controller Communications Controller Default Settings Communication Parameters Data Format Communicating with the Controller Sending Commands to the Controller Receiving Responses from the Controller Page Summary of Firmware Commands Table 3 Firmware Commands for EX II 3000SP Development Command Name Code Calibrate Extended Guidelines for Calibrate Extended Determining Target Areas Calibrate Extended Procedure Calibrate Raw Finger Only Format Raw Table 6 General Packet Formats Byte Bits 0 – Table 7 I/Q Corner Components Format Tablet Mode Stream Null Command Output Identity Pen/Finger Pen Only Reset Restore Defaults Unit Type APPENDIX A EX II 3000SP Controller Specifications Technical Specifications