30 | EX II 3000SP Controller Reference Guide |
Output Identity
Syntax: <SOH>OI<CR>
Description: Returns a
Response: <SOH>CcXxxx<CR>
where: |
|
|
Cc | = | Two ASCII characters that describe the type of 3M Touch |
|
| Systems controller. |
|
| P5 = EX II 3000SP |
Xxxx | = | Four ASCII characters that indicate the firmware version number |
|
| in decimal format. The first two characters represent the version |
|
| number; the last two characters represent the revision level. For |
|
| example, 0800 means Version 8, Revision 0 (that is, 8.0). |
Pen/Finger
Syntax: <SOH>PF<CR>
Description: The default setting for the EX II 3000SP controller. It will recognize touch from either the TouchPen or finger.
Response: <SOH>0<CR> Positive response
Pen Only
Syntax: <SOH>PO<CR>
Description: The controller will disable finger touch and will only respond to the TouchPen.
Response: <SOH>0<CR> Positive response
Reset
Syntax: <SOH>R<CR>
Description: Initializes the hardware and the firmware, causes the controller to stop sending data, and recalculates the environmental conditions (for example, stray and offset values). The Reset command also cancels the Format Raw and Calibrate Raw commands and returns the controller to normal operation.
3M Touch Systems recommends that the host system issue a Reset command whenever the host system is powered on and is attempting to establish communication with the controller.
3M Touch Systems Proprietary Information