Manuals / Brands / Computer Equipment / Computer Monitor / 3M / Computer Equipment / Computer Monitor

3M EX II 3000SP Integrating the EX II 3000SP Controller, Overview of the EX II 3000SP Touch Screen Controller, CHAPTER

1 34

Download 34 pages, 215.76 Kb

CHAPTER 1

Integrating the EX II 3000SP Controller

The 3M Touch Systems EX II 3000SP controller provides a drop-in replacement for the entire family of TouchPen controllers with all the improved features of the EX II chipset including wide dynamic range, increased noise immunity, wide operating temperature stability, reprogrammability using software utilities and inherent APAC (ungrounded) capability.

This chapter covers the following EX II 3000SP controller specifications:

•Cable connections

•Mounting requirements

•Power requirements and options

•Status LED codes

Overview of the EX II 3000SP Touch Screen Controller

The EX II 3000SP is a form, fit and functional replacement for the TP4+ controller (64-68) with a standard RS-232 serial interface. The EX II 3000SP controller, touch screen, stylus and cables are supplied separately.

3M Touch Systems Proprietary Information

Contents

Page Page Contents Appendix A EX II 3000SP Controller Specifications About This Manual What You Need to Know Important Safety Information Explanation of Symbols 3M Touch Systems Support Services 3M Touch Systems Worldwide Offices Page CHAPTER Integrating the EX II 3000SP Controller Overview of the EX II 3000SP Touch Screen Controller Figure 1 Components of the TouchPen System Note: Establishing the Data Connection Mounting the Controller Supplying Power to the Controller Using a Custom Serial Cable Design Mounting the Touch Screen Handling and ESD Protection Turning On Your System Status Light (LED) Diagnostics What's Next Installing and Using TouchWare Calibrating the Touch Screen Page EX II 3000SP Controller Communications Controller Default Settings Communication Parameters Data Format Communicating with the Controller Sending Commands to the Controller Receiving Responses from the Controller Page Summary of Firmware Commands Table 3 Firmware Commands for EX II 3000SP Development Command Name Code Calibrate Extended Guidelines for Calibrate Extended Determining Target Areas Calibrate Extended Procedure Calibrate Raw Finger Only Format Raw Table 6 General Packet Formats Byte Bits 0 – Table 7 I/Q Corner Components Format Tablet Mode Stream Null Command Output Identity Pen/Finger Pen Only Reset Restore Defaults Unit Type APPENDIX A EX II 3000SP Controller Specifications Technical Specifications