3M MP8650 manual Operating the Projector, Turning On the Projector, 1. Projector Control Panel

Section 4: Operating the Projector

4-1. Turning On the Projector

Read the Important Safeguards before operating the MP8650 projector.

Refer to Section 3 to make all cable connections. When the input cables and power cords are connected, turn on the power, adjust the size and focus of the projected image and begin your presentation.

Power On: Turn on the projector power, then turn on the power to your input sources. The projector power switch is located on the backside of the projector in the lower right corner.

Press the power switch to ON to apply power to the projector. = ON O = OFF

!Caution

Allow a projector that has been stored in a cold place to warm up to operating temperature 0°C to 35°C (32°F to 95°F) before applying power.

The Standby/Power-Onindicator (Figure 4-1) will turn amber, indicating the unit is in the standby mode.

￿Note

The lamp does not energize in the standby mode.

Remove Lens Cap: Remove the lens cap from the projection lens before energizing the lamp.

Projector Control Panel: The projector control panel is located on the side of the projector.

. . .

Energize Lamp: Press the POWER button . . . on the projector control panel or the STANDBY button

on the remote control to energize the lamp. The Lamp indicator (Figure 4-2) will turn green to indicate that the metal halide lamp is warming up.

Figure 4-1. Projector Control Panel

The Standby/Power-Onindicator (Figure 4-2) will turn from amber to green to indicate that the projector is in the operating mode. It takes a few moments for the projection lamp to reach its full light output.

￿Note

When a metal halide lamp is first turned on, it is normal for it to make noise as the gas inside the bulb heats to the proper operating temperature.

Select Input: Press the INPUT button on the control panel or RGB or VIDEO button on the remote control to select the desired video or computer source. The current input source (RGB1, RGB2, Video1 or Video2) will display in the upper right corner.

Press INPUT again or press the or arrow (remote control) to select the next input source.

Standby/

Power-On

Temperature

Lamp

Figure 4-2. Indicator Lamps

 3M 1997 3M  Multimedia Projector MP8650 11