3M MP8760 Changing Of The IR-Remote-Control Address, Changing of the IR-Remote-Control address

A-3. Changing Of The IR-Remote-Control Address

Changing of the IR-Remote-Control address:

You can choose one out of four different IR-RC addresses for the projector, so you can control four projectors separately without any interferencies to another projector.

To change an address from the standard address #1, go to the Advanced Setup menu and choose an address of your choice under the menu item RC Address (1...4). Confirm your selection with the Enter button.

After this point you can't control the projector with the IR-RC transmitter anymore until you change the transmitter address to the same address. (Of course, you still can enter the menu system and change back the address with the Control Panel of the projector!)

To change the address of the IR-RC transmitter, please press the Mode button and an address number (buttons 1,2,3 or 4) simultaneously for 4 seconds on the IR-RC transmitter.

After this you should be able to control the projector by IR-RC again if you've choosen the same address for the projector and the IR-RC transmitter.

A-4. Resetting The Projector To Factory Default Settings

The factory default settings of the projector can be restored by pressing Enter and Mute simultaneously on the control panel when switching on the main power switch of the projector and pressing the Standby button afterwards.

The projector will start immediately and the message “Parameter factory settings restored” displayed in the starting screen will indicate the default settings are reset.

If you've had selected another menu language as english, which is the default language, you'll have to select your menu language again.

ENGLISH

 3M IPC 2000 3M Multimedia Projector MP8760 27