Load Defaults
The complete list of defaults is shown in the Default Table at the end of this manual.
Baud Rate
Data Bits
With the printer in the setup menu and with CONFIGURE [NEXT/OK] as the last item printed, press OK (right side) to access the CONFIGURE menu. The following is printed:
LOAD DEFAULTS gives you the opportunity to reset the printer to all default settings (shown below).
Choose OK to do this or NEXT to go to the next param- eter. The following is printed:
Baud rate is the next parameter you can set in the CONFIGURE menu. The complete list of parameters and their possible values is shown below.
The sample list above shows the current baud rate is 2400. To accept this, press OK (right side) or view the next baud rate value by pressing NEXT (left side). Press OK when the baud rate you want is displayed
.
Choose from these baud rates;
300, 600, 1200, 2400, 4800, 9600, or 19200
DATA BITS is the next parameter. Choose the data bit value the same way baud rate was chosen. Choices are 7 or 8 data bits.
10
