SERVICING
DOOR TRIM
Becton Fire doors are fitted with a brushed steel finish trim as standard. The trim is secured using 3 off tabs and located in the slot section of the trim and secured with 3 off nuts. (See Fig. 11a below.)
Step 3 The trim will now lift off the remaining 2 tabs. See Fig. 11d.
Fig 11d
Step 4 Repeat the above steps in reverse to replace the trim.
Fig. 11a Location of the 3 off tabs
FIRE DOOR GLASS & SEAL
Note! To fit a tracery the trim must first be removed. The fire door can only be fitted with one item at a time.
REPLACEMENT OF THE DOOR TRIM
Ensure the appliance is cold.
Step 1 Remove the fire door.
This is carried out by opening the door (secured with a magnet) and lifting it off its hinges.
Fig 11b Lifting the door off its hinges
Step 2 Place the door on a flat surface and remove the single tab. The tracery can now be removed. (See Fig. 11c below)
If necessary the glass and seal can be removed as follows:
Ensure the appliance is cold.
Step 1 Open the fire door.
Step 2 The glass frame is secured using M5 screws. Remove all but the bottom 2 screws. See Fig. 12 below.
Fig. 12 Removing the Glass Frame
Step 3 Loosen the two remaining screws to enable you to lift off the glass frame and the glass and gasket assembly together.
To
Note! The screws must be firmly secured to reform the seal.
Fig. 11c Untightening the single tab
Becton Bunny & Becton 7 mk3 Gas stoves | 19 |
